Philips FW930 User manual - Page 16

CD English Loading the CD Changer 1 Press CD to select CD mode. 2 Press OPEN•CLOSE. ™ The CD carousel slides out. 3 Load a CD with the printed side up in the right tray. • You can load another disc in the left tray. • To load the third disc, press the DISC CHANGE button. ™ The CD carousel will rotate until the empty tray is ready for loading. 4 Press OPEN•CLOSE to close the CD carousel. ™ The total number of tracks and the playing time of the last selected disc appear on the display. Note: - To ensure good system performance, wait until the CD changer completely reads the disc(s) before proceeding. CD Direct Play You can play a CD directly by pressing the DISC 1, DISC 2 or DISC 3 button. The CD player will stop at the end of playback of the selected disc. - A lit button indicates that a disc is loaded in the disc tray. Playing a CD 1 Press PLAY É to start playback. ™ The disc tray, track number and elapsed playing time of the current track appear on the display. • To interrupt playback, press PAUSE Å. ™ The playing time flashes. • To resume playback, press PLAY É again. 2 To stop playback, press STOP•CLEAR Ç. Note: - All the available discs will play once, then stop. Disc Change You can change the outer two discs while the third inner disc is stopped or is playing. 1 Press DISC CHANGE. ™ The CD carousel slides out. 2 Replace the discs in the left and right disc trays. • If you press DISC CHANGE again during playback, the CD will stop playing. ™ The CD carousel will rotate until the inner tray is rotated out and is ready for loading. 3 Press OPEN•CLOSE to close the CD compartment. Selecting a desired track Selecting a desired track when playback is stopped 1 Press PREV í or NEXT ë until the desired track appears on the display. 2 Press PLAY É to start playback. ™ The selected track number and elapsed playing time appear on the display. Selecting a desired track during playback • Press PREV í or NEXT ë until the desired track appears on the display. ™ The selected track number and elapsed playing time appear on the display. • If you press PREV í once it will skip to the beginning of the current track and play the track again. Searching for a particular passage during playback • Press and hold à or á until the desired passage is located. ™ The volume will be reduced. • Play returns to normal when à or á is released. Programming Tracks Programming tracks of a loaded CD is possible when playback is stopped. The display will indicate the total tracks stored in the program. Up to 40 tracks can be stored in the memory in any order. When 40 tracks are stored and you attempt to store another track, the display will show "FULL". 1 Load the desired discs in the disc trays. 2 Press PROGRAM to start programming. ™ The PROGRAM flag starts flashing. ™ It will cancel any previously selected repeat mode. 3 Press the CD (CD 1•2•3) button to select the disc. 4 Press PREV í or NEXT ë to select the desired track. 5 Press PROGRAM to store the track. • Repeat steps 3 to 5 to store other discs and tracks. 6 Press STOP•CLEAR Ç once to end programming. ™ The total number of tracks programmed and total playing time appear on the display. Notes: - If the total playing time is more than "99:59" or if one of the programmed tracks has a number greater than 30, then "--:--" appears on the display instead of the total playing time. 16