Philips HTS5580W User manual - Page 28

• Weight: • Center: 1.40 kg • Speaker: 0.98~1.05 kg/each • Tall speaker: 3.73~3.81 kg/each • Cable length: • Center: 6.56 ft • Front: 9.84 ft • Rear: 32.8 ft Wireless receiver • Power supply rating: 110-240V; ~50-60 Hz • Total output power: 250 W (RMS) • Power consumption: 50 W • Standby power consumption: ” 0.45 W • Frequency response: 150 Hz ~ 20 kHz • S/N Ratio: 65 dB (A-Weighted) • Distortion: 1% • Dimensions (WxHxD): 4.96 x 5.16 x 4.96 (inches) • Weight: 1.1 kg Wireless transmitter • Frequency response: 5.8 GHz • Dimensions (WxHxD): 2.16 x 2.08 x 1.30 (inches) • Weight: 0.05 kg Dock for iPod/iPhone • Dimensions (HxD): 1.35 x 4.1 (inches) • Weight: 135 g Laser Specification • Laser Type (Diode): InGaN/AIGaN (BD), InGaAIP (DVD), A IGaAs (CD) • Wave length: 405 +5nm/-5nm (BD), 650 +13nm/-10nm (DVD), 790 +15nm/-15nm (CD) • Output power (Max. ratings): 20mW (BD), 7mW (DVD/CD) 9 Troubleshooting Warning • Risk of electric shock. Never remove the casing of the product. To keep the warranty valid, never try to repair the product yourself. If you have problems using this product, check the following points before you request service. If you still have a problem, visit www.philips.com/ welcome. If you contact Customer Care Center, you will be asked for the model and serial number of your product.The model number and serial number are on the back or bottom of your product. Write the numbers here: Model No Serial No Main unit The buttons on this home theater do not work. • Disconnect the home theater from the power outlet for a few minutes, then reconnect. Picture No picture. • Ensure that the TV is switched to the correct source for the home theater. No picture on HDMI connection. • Change the HDMI video setting or wait for 15 seconds for auto recover. • Check if the HDMI cable is faulty. Replace with a new HDMI cable. No picture on the Component (Y Pb Pr) connection. • If the HDMI video connection is set to [Auto] or [1080p/24Hz], there is no video output through the component connection. Change the HDMI video setting or remove the HDMI connection. No high-definition video signal on the TV. • Ensure that the disc contains high-deÀnition video. • Ensure that the TV supports high-deÀnition video. 26 EN