Philips MCM196D User manual - Page 18

English Radio Reception MICRO SYSTEM MCM196D Tuning to radio stations 1 Select TUNER source. 2 Press SOURCE on the set repeatedly or press TUNER on the remote repeatedly until the desired waveband (FM or MW) is displayed. 3 Press down on TUNING 4 ¢ (or 4 ¢ on the remote control) and release button. ➜ The radio automatically tunes to a station with sufficient reception. Display indication during automatic tuning: SEARCH. 4 Repeat step 3 if necessary until you find the desired station. ● To tune to a weak station, press TUNING 4 ¢ (or 4 ¢ on the remote control) briefly and repeatedly until you have found optimal reception. Programming radio stations You can store up to a total of 40 radio stations in the memory. Automatic programming Automatic programming will start with a chosen preset number. From this preset number upwards, former programmed radio stations will be overridden.The system will only programme stations which are not in the memory already. 1 Press ALBUM/PRESET 4 3 to select the preset number where programming should start. Note: - If no preset number is selected, default is preset (1) and all your presets will be overridden. 2 Press PROGRAM for more than 2 seconds to activate programming. ➜ AUTO is displayed and available stations are programmed in order of waveband reception strength.The first preset automatically stored will then be played. Manual programming 1 Tune to your desired station (see Tuning to radio stations). 2 Press PROGRAM to activate programming. ➜ PROG flashes in the display. 3 Press ALBUM/PRESET 4 3 to allocate a number from 1 to 20 to this station. 4 Press PROGRAM again to confirm the setting. ➜ PROG disappears, the preset number and the frequency of the preset station are shown. 5 Repeat the above four steps to store other stations. ● You can override a preset station by storing another frequency in its place. Tuning to preset radio stations ● Press ALBUM/PRESET 4 3 until the desired preset station is displayed. 18