Philips MX5500D User manual - Page 25

English Getting Started Setting the speakers' channels You can adjust the delay times (center and surround only) and volume level for individual speakers. These adjustments let you optimize the sound according to your surroundings and setup. Speaker settings are only active on Multichannel audio outputs. Digital Output Night mode Analog Output Speakers Speaker Layout PCM Output Personal setting ... Set Speaker SeFttriongnst L & R Center Surr L & R Sub Woofer OK to exit On 3 ms 3 dB 6 dB AB C 1 Press SURR. (or SURROUND on the front panel) repeatedly to select 'Multi-channel.' 2 In disc mode, press SYSTEM MENU. 3 Select icon and press 4. 4 Use the joystick (1 2 3 4) on the remote to navigate in the menu. Move to and press 2. Move to 'Speakers' and press 2. 5 Press 3 4 to select (Front L&R, Center, Surr L&R, Sub Woofer), then press 2 to enter the speaker setting menu. ➜ The test tone will be automatically generated. 6 Use 3 4 to adjust the settings for each speaker to suit your surround sound needs. These adjustments may include : A Turning on or off the sound output. B Delay time settings - use the longer delay settings when the surround speakers are closer to the listener than the front speakers. C Adjusting the volume levels for one or both speakers until the sound evens. 7 Press OK to confirm. To remove the menu Press SYSTEM MENU. Step 5: Setting language preference You can select your preferred language settings so that this DVD system will automatically switch to the language for you whenever you load a disc. If the language selected is not available on the disc, the disc's default setting language will be used instead. Except the DVD system's menu language, it will remain once selected. SETUP MENU ➠ Parental Control Password Menu Language Defaults English Français Audio Language Subtitle Disc Menu English English English Go to language setup page 1 In disc mode, stop playback and press SYSTEM MENU. 2 Select icon and press 4. 3 Use the joystick (1 2 3 4) on the remote to navigate in the menu. Move to and press 2. Move to 'Menu Language' and press 2. 4 Select a language and press OK. 5 Use the joystick (1 2 3 4) on the remote to navigate in the menu. Move to and press 2. Move to one of the following and press 2. - 'Audio Language' (disc's soundtrack) - 'Subtitle' (disc's subtitles) - 'Disc Menu' (disc's menu) 6 Select a language and press OK. 7 Repeat steps 5~6 for other settings. To remove the menu Press SYSTEM MENU. 23