Pioneer AVHP5000DVD Owner's Manual - Page 14
Resetting the microprocessor, Feature demo mode, Before You Start
UPC - 012562883489
View all Pioneer AVHP5000DVD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Section 02 Before You Start Attaching the front panel 1 Slide the front panel to the left. Front panel and the head unit are jointed on the left side. Make sure that the front panel has been jointed to the head unit. 3 Press RESET with a pen tip or other pointed instrument. 2 Press the right side of the front panel until it is firmly seated. # If you can't attach the front panel to the head unit successfully, try again. Front panel may be damaged if you attach the front panel forcedly. Resetting the microprocessor Pressing RESET lets you reset the microprocessor to its initial settings without changing the bookmark information. The microprocessor must be reset under the following conditions: ! Prior to using this unit for the first time after installation ! If the unit fails to operate properly ! When strange or incorrect messages ap- pear on the display 1 Turn the ignition switch OFF. 2 Remove the front panel. Refer to Removing the front panel on the previous page. RESET button Note After completing connections or when you want to erase all memorized settings or return the unit to its initial (factory) settings, switch your engine ON or set the ignition switch to ACC ON before pressing RESET. Feature demo mode The feature demo automatically starts when you select the source OFF. The demo continues while the ignition switch is set to ACC or ON. To cancel the feature demo, press and hold VOLUME/MUTE. To restart the feature demo, press and hold VOLUME/MUTE again. Remember that if the feature demo continues operating when the car engine is turned off, it may drain battery power. Important The red lead (ACC) of this unit should be connected to a terminal coupled with ignition switch on/off operations. If this is not done, the vehicle battery may be drained. 14 En