Pioneer CD-R55 Owner's Manual - Page 1
Pioneer CD-R55 - Remote Control - Infrared Manual
UPC - 012562200842
View all Pioneer CD-R55 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
Owner's Manual Fig. 1 Mode d'emploi Remote control Télécommande CD-R55 PIONEER CORPORATION 4-1, MEGURO 1-CHOME, MEGURO-KU TOKYO 153-8654, JAPAN PIONEER ELECTRONICS (USA) INC. P.O. Box 1540, Long Beach, California 90801-1540, U.S.A. TEL: (800) 421-1404 PIONEER EUROPE NV Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium TEL: (0) 3/570.05.11 PIONEER ELECTRONICS ASIACENTRE PTE. LTD. 253 Alexandra Road, #04-01, Singapore 159936 TEL: 65-6472-7555 PIONEER ELECTRONICS AUSTRALIA PTY. LTD. 178-184 Boundary Road, Braeside, Victoria 3195, Australia TEL: (03) 9586-6300 PIONEER ELECTRONICS OF CANADA, INC. 300 Allstate Parkway, Markham, Ontario L3R OP2, Canada TEL: 1-877-283-5901 PIONEER ELECTRONICS DE MEXICO, S.A. de C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico, D.F. 11000 TEL: 55-9178-4270 44號13 02) 2521-3588 9樓901-6 0852) 2848-6488 Published by Pioneer Corporation. Copyright © 2006 by Pioneer Corporation. All rights reserved. Publié par Pioneer Corporation. Copyright © 2006 par Pioneer Corporation. Tous droits réservés. Printed in China Imprimé en Chine E 23 4 l k 1 j i h g f 5 6 7 8 9 a b c d e Fig. 2 En Before You Start ! When using for the first time, pull out the film protruding from the tray. If you want to dispose this product, do not mix it with general household waste. There is a separate collection system for used electronic products in accordance with legislation that requires proper treatment, recovery and recycling. Private households in the 25 member states of the EU, in Switzerland and Norway may return their used electronic products free of charge to designated collection facilities or to a retailer (if you purchase a similar new one). For countries not mentioned above, please contact your local authorities for the correct method of disposal. By doing so you will ensure that your disposed product undergoes the necessary treatment, recovery and recycling and thus prevent potential negative effects on the environment and human health. Information to User Alteration or modifications carried out without appropriate authorization may invalidate the user's right to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Use and care of the remote control Installing the battery (Fig. 1) Slide the tray out on the back of the remote control and insert the battery with the plus (+) and minus (-) poles pointing in the proper direction. WARNING ! Handling the cord on this product or cords as- sociated with accessories sold with the product may expose you to chemicals listed on proposition 65 known to the State of California and other governmental entities to cause cancer and birth defects or other reproductive harm. Wash hands after handling. ! Keep the battery out of the reach of children. Should the battery be swallowed, immediately consult a doctor. CAUTION ! Do not allow this unit to come into contact with liquids. Electrical shock could result. Also, this unit damage, smoke, and overheat could result from contact with liquids. ! Do not disassemble or modify this unit. To do so may cause a malfunction. ! Always keep the volume low enough so that you can hear sounds from outside the vehicle. ! Use only one CR2025 (3 V) lithium battery. ! Always check carefully that you are loading the battery with its plus (+) and minus (-) poles facing in the proper directions. ! Remove the battery if the remote control is not used for a month or longer. ! Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type. ! Do not handle the battery with metallic tools. ! Do not store the battery with metallic materials. ! In the event of battery leakage, wipe the remote control completely clean and install a new battery. ! When disposing of used batteries, please comply with governmental regulations or environmental public institutions' rules that apply in your country/area. ! "Perchlorate Material - special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate. (Applicable to California, U.S.A.)" Using the remote control Point the remote control in the direction of the front panel to operate. En Before You Start ! The remote control may not function properly in direct sunlight. Important ! Do not store the remote control in high temperatures or direct sunlight. ! Do not let the remote control fall onto the floor, where it may become jammed under the brake or accelerator pedal. Using the remote control operation mode switch There are three remote control operation modes on the remote control. AVH mode operation When operating an AV Receiver (e.g., AVHP5900DVD) with this remote control, the mode is normally switched to AVH. DVD mode operation When operating a Pioneer DVD player (e.g., XDV-P6) with this remote control, the mode is switched to DVD. If you switch the mode to DVD, the joystick and 0 to 10 operations are changed for DVD player. Setting remote control code type When the remote control operation mode switch is set to DVD, changing the remote control code type enables you to operate the Pioneer DVD player with this remote control. There are three remote codes, code type A, code type B and code type AVH. ! When operating an AV Receiver (e.g., AVH- P5900DVD), select code AVH. ! When operating a multi-DVD player (e.g., XDV-P6), select code A. ! When operating a DVD navigation unit, se- lect code B. 1 Set the remote control selection switch on the left side of the remote control to the appropriate position with a pen tip or other pointed instrument . ! If you select AVH mode, there is no need to take the following procedure. ! If you select A/B mode, take the following procedure and change the code type to the appropriate type. 2 Press 0 and CLEAR on the remote control simultaneously to change the code type. Initially, the code type is set to A. Each time you press 0 and CLEAR simultaneously on the remote control the code type switches between A and B. TV mode operation When operating a Pioneer TV tuner (e.g., GEXP5700TV (P)) with this remote control, the mode is switched to TV. If you switch the mode to TV, the joystick operation is changed for TV tuner. In TV mode, only buttons shown below can be used. ! SOURCE button ! ATT button ! VOLUME buttons ! Joystick ! DIRECT button ! REAR SOURCE button Specifications Power source 3 V DC (Lithium battery; CR2025) Dimensions (W × H × D) ... 54 × 149 × 13 mm (2-1/8 × 5-7/8 × 1/2 in.) Weight 59 g (2 oz) (including battery) Infrared remote control Wavelength 945 nm Output typ; 10 mw/sr per Infrared LED Note Specifications and the design are subject to possible modifications without notice due to improvements. En