Pioneer CNSD-250FM Upgrade Guide - Page 21

Instructions for upgrading Chapter 04 Instructions for upgrading Getting the password for authentication Web-connected computer is required for online issuance of password. For upgrade, an unique password issued online is necessary. Access the website with your PC and get your password. The following information is required. ! Media Number (MEDIA NUMBER) printed on supplied Media Number Card (MEDIA NUMBER CARD) ! Device Number (DEVICE NUMBER) of your navigation system 1 Access on the following website to issue your password. http://www.pioneer.eu/UnlockNavgate For issuing the password, follow the instruction on the website. 2 Record the password that you received. You need to input this password accurately. Write down your password to avoid mistakes. 2 Insert the upgrade SD memory card into the SD card slot. 3 Turn the ignition switch OFF and back ON to reboot the navigation system. After a short pause, the device number will appear. 4 Touch [OK]. After a short pause, the keyboard for entering the password will appear. p To cancel the upgrade, touch [Cancel]. 5 Enter the password for authentication that you obtained, then touch [Done]. Upgrade procedures Upgrading the software programme and the map database This section describes the upgrade procedures for your navigation system. p The upgrade takes approximately 40 min- utes in total. p If you use AVIC-F500BT, be sure to follow the instructions given below. ! Turn the navigation unit's power com- pletely off by pressing and holding the Power button. ! Never start upgrading when the navigation unit runs with the battery. Otherwise, the upgrade cannot complete because the battery runs out. 1 Park your vehicle in a safe place and apply the handbrake. After you touch [Done], the system starts the authentication. When the authentication is finished properly, a message for confirmation will appear. 6 Touch [Yes] to start the upgrade. Engb 21