Pioneer D814-K Installation Manual - Page 37

Listening to your system 06 • If you switch on Midnight listening, Loudness, or the Tone controls when DIRECT is selected, the receiver automatically switches to STEREO. Choosing the input signal • Default setting: AUTO You need to hook up a component to both analog and digital inputs on the rear of the receiver to select between input signals. • You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make the proper digital connections (page 17) and set the signal input to DIGITAL. • Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your DVD player. STATION TUNING ADVANCED STEREO/ STANDARD SURROUND DIRECT SIGNAL MIDNIGHT/ SELECT LOUDNESS SPEAKERS SB CH MODE MULTI JOG TONE QUICK SETUP TUNER EDIT CLASS BAND LISTENING MODE MPX INPUT ATT FL DIMMER MCACC SETUP MIC DIGITAL IN VIDEO INPUT S-VIDEO VIDEO L AUDIO R MULTI JOG • Press SIGNAL SELECT on the front panel to select the input signal corresponding to the source component. Each press cycles through the options as follows: • AUTO - This automatically switches to DIGITAL if a digital source is detected, otherwise it remains on ANALOG. • DVD 5.1ch - Selects the multichannel inputs (only appears when DVD/LD is selected). • ANALOG - Selects the analog inputs. • DIGITAL - Selects the digital input. When set to DIGITAL or AUTO, 2 DIGITAL lights when a Dolby Digital signal is input, and DTS lights when a DTS signal is input. • This receiver can only play back Dolby Digital, PCM (32kHz-96 kHz) and DTS digital signal formats (including DTS 96kHz/24 bit). With other digital signal formats, set to ANALOG. 37 En