Pioneer DJM-850 Operation Manual - Page 12
Click the [USB Output Level] pull-down menu. - k dj mixer
View all Pioneer DJM-850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Setting the audio data output from this unit to the computer Display the setting utility before starting. 1 Click the [MIXER OUTPUT] tab. Click the [ASIO] tab. 2 Click the [Mixer Audio Output] pull-down menu. Select and set the audio data to be output to the computer from the flow of audio signals inside this unit. CH1 CH2 CH3 CH4 CH1 Timecode PHONO1 CH2 Timecode CD/LINE1 CH3 Timecode CD/LINE1 CH4 Timecode PHONO1 CH1 Timecode CD/LINE1 Post CH1 Fader2 Cross Fader A2 Cross Fader B2 CH2 Timecode LINE1 Post CH2 Fader2 Cross Fader A2 Cross Fader B2 CH3 Timecode LINE1 Post CH3 Fader2 Cross Fader A2 Cross Fader B2 CH4 Timecode CD/LINE1 Post CH4 Fader2 Cross Fader A2 Cross Fader B2 MIC REC OUT2 MIC REC OUT2 MIC REC OUT2 MIC REC OUT2 None None None None 1 The audio data is output with the same volume at which it is input to this unit, regardless of the [USB Output Level] setting. 2 When using for any purposes other than sound recording, pay attention to set the DJ software so that sound loops are not generated. If sound loops are generated, sound with an unintended volume might be input or output. 3 Click the [USB Output Level] pull-down menu. Adjust the volume of the audio data output from this unit. ! The [USB Output Level] setting is applied equally to all audio data. However, when 1 on the table at step 2 is selected, the audio data is output with the same volume at which it is input to this unit. ! If not enough volume can be achieved with the DJ software's volume adjustment alone, change the [USB Output Level] setting to adjust the volume of the audio data output from this unit. Note that the sound will be distorted if the volume is raised too high. Adjusting the buffer size (when using Windows ASIO) If an application using this unit as the default audio device (DJ software, etc.) is running, quit that application before adjusting the buffer size. Display the setting utility before starting. ! If the buffer size is made large, drops in audio data (breaks in the sound) occur less easily, but the time lag due to the delay in the transfer of the audio data (latency) increases. Checking the version of the driver software Display the setting utility before starting. Click the [About] tab. Checking the latest information on the driver software For the latest information on the driver software for exclusive use with this unit, visit our website shown below. http://pioneerdj.com/support/ ! Operation cannot be guaranteed when multiple units of this mixer are connected to a single computer. 12 En