Pioneer DJM-850 Operation Manual - Page 20

SPIRAL1 2 This function adds a reverberation effect to the input sound. When the delay time is changed, the pitch changes simultaneously. Input sound turned off Fade-out 1 beat Time BEAT c, d buttons (parameter 1) Use these to set a time delay of 1/8 - 16/1 with respect to the time of one beat of the BPM. TIME control (parameter 2) Use this to set the delay time. 10 to 4000 (ms) LEVEL/DEPTH control (parameter 3) Use this to set the balance between the original sound and the effect sound and to set the quantitative parameter. REVERB1 2 This function adds a reverberation effect to the input sound. Direct sound Early reflected sound Level Reverberations 1% Time 100% BEAT c, d buttons (parameter 1) Use these to set the extent of the reverberation effect, from 1 - 100 %. TIME control (parameter 2) Use this to set the degree of the reverb effect. 1 - 100 (%) LEVEL/DEPTH control (parameter 3) Use this to set the balance between the original sound and the effect sound and to set the cut-off frequency of the filter through which the effect sound passes. TRANS1 The sound is cut according to the beat fraction set with the [BEAT c, d] buttons. Cut Cut 1/1 beat Time BEAT c, d buttons (parameter 1) Use these to set a cut time of 1/16 - 16/1 with respect to the time of one beat of the BPM. TIME control (parameter 2) Use this to set the effect time. 10 to 16000 (ms) LEVEL/DEPTH control (parameter 3) Sets the balance between the original sound and the effect sound. Use this to set the cycle at which the cut-off freTIME control (parameter 2) quency is moved. 10 to 32000 (ms) LEVEL/DEPTH control (parameter 3) The further the control is turned clockwise, the more the effect is stressed. FLANGER1 A 1-cycle flanger effect is produced according to the beat fraction set with the [BEAT c, d] buttons. Short delay Cycle Time BEAT c, d buttons (parameter 1) Use these to set the 1/4 - 64/1 effect time with respect to the time of one beat of the BPM. Use this to set the cycle by which the flanger effect TIME control (parameter 2) moves. 10 to 32000 (ms) LEVEL/DEPTH control (parameter 3) The further the control is turned clockwise, the more the effect is stressed. When turned all the way counterclockwise, only the original sound is output. PHASER1 The phaser effect changes according to the beat fraction set with the [BEAT c, d] buttons. Phase shift Cycle Time BEAT c, d buttons (parameter 1) Use these to set the cycle for moving the phaser effect as of time of 1/4 - 64/1 with respect to the time of one beat of the BPM. This sets the cycle by which the phaser effect is TIME control (parameter 2) moved. 10 to 32000 (ms) LEVEL/DEPTH control (parameter 3) The further the control is turned clockwise, the more the effect is stressed. When turned all the way counterclockwise, only the original sound is output. ROBOT1 The original sound is changed to a sound like one produced by a robot. BEAT c, d buttons (parameter 1) Use these to set the degree of the effect sound, from -100 - 100 %. TIME control (parameter 2) Use this to set the degree of the effect sound. -100-100 (%) LEVEL/DEPTH control (parameter 3) Sets the balance between the original sound and the effect sound. FILTER1 The filter's cutoff frequency changes according to the beat fraction set with the [BEAT c, d] buttons. BEAT c, d buttons (parameter 1) 20 En Frequency Use these to set the cycle for moving the cut-off frequency as a time of 1/4 - 64/1 with respect to the time of one beat of the BPM.