Pioneer DV-49AV Owner's Manual - Page 12

02 Connecting using the S-Video Connecting using the output component video output If your TV (or other equipment) has an S-Video (S1) input, you can use the S-Video output on this player instead of the standard (composite) output for a better quality picture. • Use an S-Video cable (not supplied) to connect the S-VIDEO OUT to an S-Video input on your TV (or monitor or AV receiver). Line up the small triangle above the jack with the same mark on the plug before plugging in. You can use the component video output instead of the standard video out jack to connect this player to your TV (or other equipment). This should give you the best quality picture from the three types of video output available. • Use a component video cable (not supplied) to connect the COMPONENT VIDEO OUT jacks to a component video input on your TV, monitor or AV receiver. To S-Video input TV PB VIDEO OUT SL C L PR Y SR SW R HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT AUDIO OUT (5.1ch) To component video input TV PB VIDEO OUT SL C L PR Y SR SW R HDMI OUT COMPONENT VIDEO OUT S-VIDEO OUT AUDIO OUT (5.1ch) Watching progressive scan video from the component video outputs This player can output progressive scan video from the component video output. Compared to interlace video, progressive scan video effectively doubles the scanning rate of the picture, resulting in a very stable, flicker-free image. To set up the player for use with a progressive scan TV, see Video Output settings on page 41. When the player is set to output progressive scan video, the PRGSVE indicator lights in the front panel display. 12 En