Pioneer PD-F907 Owner's Manual - Page 5

Cautions Regarding Handling - cd player

Page 5 highlights

CAUTIONS REGARDING HANDLING Location Install the player in a well-ventilated location where it will not be exposed to high temperatures or humidity. Do not install the player in a location which is exposed to direct rays of the sun, or near stoves or radiators. Excessive heat can adversely affect the cabinet and internal components. Installation of the player in a damp or dusty environment may also result in a malfunction or an accident. (Avoid installation near cookers etc., where the player may be exposed to oily smoke, steam or heat.) Do not install the player on a tottered stand nor in an unstable or inclined place. Precautions regarding installation ÷ Placing and using the compact disc player for long periods on heat-generating sources such as amplifiers will affect performance. Avoid placing the player on heat-generating sources. ÷ Install this compact disc player as far as possible from tuners and TV sets. A compact disc player installed in close proximity to such equipment may cause noise or degradation of the picture. ÷ Such noise may be particularly noticeable when an indoor antenna is used. In such cases, make use of an outdoor antenna, or turn off power to the compact disc player. ÷ Please place this unit on a level surface. Condensation When this unit is brought into a warm room from previously cold surroundings or when the room temperature rises sharply, condensation may form inside, and the unit may not be able to attain its full performance. If this occurs, allow the unit to stand for about an hour or raise the room temperature gradually. Cleaning and handling compact discs ÷ The presence of fingerprints or smudges on the surface of the disc will not directly affect the recorded signals, but depending on the degree of contamination, the brightness of the light reflected from the signal surfaces may be reduced, causing degradation of sound quality. Always keep your discs clean by wiping them gently with a soft cloth from the inner edge toward the outer periphery. ÷ If a disc becomes very dirty, dip a soft cloth in water, and after wringing it out well, wipe the dirt away gently, and then remove any water drops with another soft, dry cloth. ÷ Do not use record cleaning sprays or anti-static agents on discs. Also, never clean discs with benzene, thinner, or other volatile solvents, since damage to the disc surface may result. Cleaning the player To clean the PLAYER, wipe with a soft, dry cloth. For stubborn dirt, wet a soft cloth with a mild detergent solution made by diluting one part detergent to 5 or 6 parts water, wring well, then wipe off the dirt. Also use a dry cloth to wipe the surface dry. Do not use volatile liquids such as benzene and thinner which are harmful to the unit. Storing discs ÷ Discs are made of the same kinds of plastic used for conventional analog audio records. Be careful not to allow discs to warp; always store discs in their cases vertically, avoiding locations with high heat or humidity, or extremely low temperatures. Avoid leaving discs in cars, since the seat of a car in direct sunlight can become unbelievably hot. ÷ Always read and abide by the precautionary notes listed on disc labels. Record cleaning sprays Thinner Benzene With this unit, use a Compact Disc carrying the mark shown below. Do not use other disc, for this may result in malfunction or damage. ÷ When holding discs, do not touch their signal surfaces. Hold by the edges, or by one edge and the center hole. ÷ Do not affix gummed labels or tape to the label surfaces. Also, do not scratch or damage the label. ÷ Discs rotate at high speed inside the player. Do not use damaged (cracked or warped) discs. ÷ Do not play a CD with a special shape (having other shape than a circular disc, such as a heart shaped disc). Otherwise malfunction may occur. ' BEFORE OPERATING OPERATIONS BASIC VARIOUS OPERATIONS CD lens cleaner The player's pickup lens should not become dirty in normal use, but if for some reason it should malfunction due to soiling, consult your nearest PIONEER authorized service center. Lens cleaners for CD players are commercially available, but special care should be exercised in their use since some may cause damage to the lens. Re-transporting When re-transporting this unit in the future, remove all discs from the rack. Turn off the STANDBY/ON switch, wait for "OFF" to go out from the display, and unplug the power cord. 5 En

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20

BASIC
OPERATIONS
BEFORE
OPERATING
VARIOUS
OPERATIONS
5
<PRB1268>
En
CAUTIONS REGARDING HANDLING
Location
Install the player in a well-ventilated location where it will not be
exposed to high temperatures or humidity.
Do not install the player in a location which is exposed to direct
rays of the sun, or near stoves or radiators. Excessive heat can
adversely affect the cabinet and internal components.
Installation
of the player in a damp or dusty environment may also result in a
malfunction or an accident.
(Avoid installation near cookers etc.,
where the player may be exposed to oily smoke, steam or heat.)
Do not install the player on a tottered stand nor in an unstable or
inclined place.
Precautions regarding installation
÷
Placing and using the compact disc player for long periods on
heat-generating sources such as amplifiers will affect perfor-
mance. Avoid placing the player on heat-generating sources.
÷
Install this compact disc player as far as possible from tuners
and TV sets. A compact disc player installed in close proximity
to such equipment may cause noise or degradation of the pic-
ture.
÷
Such noise may be particularly noticeable when an indoor an-
tenna is used. In such
cases, make use of an outdoor antenna,
or turn off power to the compact disc player.
÷
Please place this unit on a level surface.
Cleaning the player
To clean the PLAYER, wipe with a soft, dry cloth. For stubborn
dirt, wet a soft cloth with a mild detergent solution made by dilut-
ing one part detergent to 5 or 6 parts water, wring well, then wipe
off the dirt. Also use a dry cloth to wipe the surface dry. Do not
use volatile liquids such as benzene and thinner which are harmful
to the unit.
Storing discs
÷
Discs are made of the same kinds of plastic used for conven-
tional analog audio records. Be careful not to allow discs to
warp; always store discs in their cases vertically, avoiding loca-
tions with high heat or humidity, or extremely low tempera-
tures. Avoid leaving discs in cars, since the seat of a car in
direct sunlight can become unbelievably hot.
÷
Always read and abide by the precautionary notes listed on disc
labels.
CD lens cleaner
The player's pickup lens should not become dirty in normal use, but
if for some reason it should malfunction due to soiling, consult your
nearest PIONEER authorized service center.
Lens cleaners for CD
players are commercially available, but special care should be exer-
cised in their use since some may cause damage to the lens.
Condensation
When this unit is brought into a warm room from previously cold
surroundings or when the room temperature rises sharply, con-
densation may form inside, and the unit may not be able to attain
its full performance. If this occurs, allow the unit to stand for about
an hour or raise the room temperature gradually.
Cleaning and handling compact discs
÷
The presence of fingerprints or smudges on the surface of the
disc will not directly affect the recorded signals, but depending
on the degree of contamination, the brightness of the light
reflected from the signal surfaces may be reduced, causing
degradation of sound quality. Always keep your discs clean by
wiping them gently with a soft cloth from the inner edge to-
ward the outer periphery.
BEFORE
OPERATING
÷
If a disc becomes very dirty, dip a soft cloth in water, and after
wringing it out well, wipe the dirt away gently, and then remove
any water drops with another soft, dry cloth.
÷
Do not use record cleaning sprays or anti-static agents on discs.
Also, never clean discs with benzene, thinner, or other volatile
solvents, since damage to the disc surface may result.
Record
cleaning
sprays
Thinner
Benzene
With this unit, use a Compact Disc carrying the mark shown
below. Do not use other disc, for this may result in malfunction
or damage.
÷
When holding discs, do not touch their signal surfaces. Hold by
the edges, or by one edge and the center hole.
÷
Do not affix gummed labels or tape to the label surfaces. Also,
do not scratch or damage the label.
÷
Discs rotate at high speed inside the player. Do not use dam-
aged (cracked or warped) discs.
÷
Do not play a CD with a special shape (having other shape than
a circular disc, such as a heart shaped disc). Otherwise mal-
function may occur.
'
Re-transporting
When re-transporting this unit in the future, remove all discs from the
rack.
Turn off the
STANDBY/ON switch, wait for "OFF" to go out from
the display, and unplug the power cord.