Pioneer VSX23TXH Owner's Manual - Page 88

10 The Advanced MCACC menu Output PC Before continuing, make sure you have completed step 2 in Checking MCACC Data on page 86. The data measured with the Advanced MCACC function is transmitted to the connected computer.1 The 3D graphs of the reverb characteristics before and after calibration and the MCACC results (parameters) can be checked. 1 Select 'Output PC' from MCACC Data Check menu and press ENTER. When the receiver is ready for transmission, Start the MCACC application on your PC shows on the GUI screen. 2f.Output PC A/V RECEIVER Start the MCACC application on your PC. Exit Cancel 2 Start the MCACC application on your computer. Follow the instructions provided with the application. It will take about ten seconds for the transmission to complete, then you will be able to analyze the output on your computer. The various parameters and the reverb characteristics data used for display on the computer are not cleared when the power is turned off. If the reverb characteristics are re-measured, however, the data is overwritten.2 3 When you're finished, press RETURN. You will return to the MCACC Data Check menu. Continue with other operations in the MCACC Data Check menu if necessary. Press RETURN again to exit the MCACC Data Check menu. Data Management This system allows you to store up to six MCACC presets, allowing you to calibrate your system for different listening positions (or frequency adjustments for the same listening position).3 This is useful for alternate settings to match the kind of source you're listening to and where you're sitting (for example, watching movies from a sofa, or playing a video game close to the TV). From this menu you can copy from one preset to another, name presets for easier identification and clear any ones you don't need. 1 Press RECEIVER , then press HOME MENU. A Graphical User Interface (GUI) screen appears on your TV. Use and ENTER to navigate through the screens and select menu items. Press RETURN to confirm and exit the current menu. 2 Select 'Data Management' from the HOME MENU. HOME MENU A/V RECEIVER 1. Advanced MCACC 2. MCACC Data Check 3. Data Management 4. System Setup 3.Data Management A/V RECEIVER a. Memory Rename b. MCACC Memory Copy c. MCACC Memory Clear Exit Return Exit Return 3 Select the setting you want to adjust. • Memory Rename - Name your MCACC presets for easy identification (see Renaming MCACC presets below). • MCACC Memory Copy - Copy settings from one MCACC preset to another (see Copying MCACC preset data below). • MCACC Memory Clear - Clear any MCACC presets that you don't want (see Clearing MCACC presets on page 89). Note 1 To transmit data, the receiver and computer must be connected using an RS-232C cable and a special application must be installed on the computer. See Connecting a PC for Advanced MCACC output on page 36 for more on this. 2 Only one set of reverb characteristics is stored on the receiver. If you wish to compare several different measurement results, transmit the data to the computer each time reverb measurements are taken. 3 This can be done in Automatically setting up for surround sound (Auto MCACC) on page 41 or Automatic MCACC (Expert) on page 78, either of which you should have already completed. 88 En