Pioneer djm909 Owner's Manual - Page 25

EFFECT FUNCTIONS No. Name 27 PHASER1 28 PHASER2 29 TOUCH PHASER1 30 TOUCH PHASER2 31 FILTER (LPF) 32 FILTER (HPF) 33 FILTER (BPF) 34 FILTER PAN 35 COMPRESSOR Parameter 1 (TIME/SELECT dial) Explanation Setting range (unit) Set period of phase effect frequency shift. 10 - 32000 (msec) Set period of phase effect frequency shift. 10 - 32000 (msec) Set sensitivity corresponding to 1 - 100 (%) input volume. Set sensitivity corresponding to 1 - 100 (%) input volume. Set period of cutoff frequency shift. 10 - 32000 (msec) Set period of cutoff frequency shift. 10 - 32000 (msec) Set period of center frequency shift. 10 - 32000 (msec) Set period of cutoff frequency shift. 10 - 32000 (msec) Set time until completely compressed. The time required to return to the original state is simultaneously set at the same value. 1 - 100 (msec) Parameter 2 (MIX/DEPTH dial) Explanation Rotate to right for stronger effect. Rotate to right for stronger effect. Rotate to right for stronger effect. Rotate to right for stronger effect. Rotate to right for increased resonance and more unusual sound. Rotate to right for increased resonance and more unusual sound. Rotate to right for increased resonance and more unusual sound. Rotate to right for increased resonance and more unusual sound. Change threshold level. Rotate to right for stronger effect. (*1) When the channel fader or cross fader is used to lowering sound volume, no effect sounds will be heard, even if monitor SELECT switch is set to the [EFFECT] position. (*2) When EFFECT switch is turned OFF, no effect sounds will be heard even if the monitor SELECT switch is set to the [EFFECT] position. 7 Fader effects No. Name 36 FADER ROLL (*2) 37 FADER MULTI TAP DELAY (*1) 38 FADER TRANS PAN 39 FADER PITCH SHIFTER 40 FADER RING 41 FADER VOCODER1 42 FADER VOCODER2 43 FADER FILTER (LPF) 44 FADER FILTER (HPF) 45 FADER FILTER (BPF) Parameter 1 (TIME/SELECT dial) Explanation Setting range (unit) Set reference ROLL time 40 - 10000 (msec) Set reference effect time 8 - 1200 (msec) Set reference effect time. 40 - 2000 (msec) Set type of pitch change. 1 - 3 Change fundamental frequency of effect sound. 500 - 8000 (Hz) Set sensitivity corresponding to input volume 1 - 100 (%) - - - - - - Parameter 2 (MIX/DEPTH dial) Explanation Set balance between source and ROLL sounds. Set balance between source and delay sounds. Set balance between source and effect sounds. Set balance between source and pitch-shifted sounds. Change effect sound level. Fader lever Explanation Change roll time Change reference beat time. Change cut time Change pitch of input sound. Change frequency of effect sound Adjust volume of code selected on panel menu. Rotate to right for increased resonance and more unusual sound. Rotate to right for increased resonance and more unusual sound. Rotate to right for increased resonance and more unusual sound. Change fundamental frequency of oscillating sound. Changes cutoff frequency of lowpass filter. Changes cutoff frequency of highpass filter. Changes band-pass filter's center frequency. 25