Poulan C36C User Manual - Page 7

1 MOWER DECK BAFFLE (See Fig. 1) Use Hardware - - GROUP "A" 1. Raise your tractor mower deck to its highest position. 2. Install the hex bolts, locknuts and acorn nuts through mower deck housing as shown. 3. Tighten all hardware securely. ACORN NUT DISCHARGE GUARD ACORN NUT LOCKNUT LOCKNUT 3 COVER SEAL (See Fig. 3) No hardware required 1. Align mark on seal with mark at cover opening. 2. Work seal into opening so cover sits between flanges of seal. ALIGNMENT MARKS HEX BOLT FIG. 1 HEX BOLT 2 REAR MOUNTING BRACKET (See Figs. 2A & 2B) NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "B" and disregard the remaining Step 2 instructions. 02462 SHOULDER BOLTS LANCED TABS TOWARD BOTTOM FIG. 2A If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below. Use Hardware - - GROUP "B" 1. Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely. 2. Hang the mounting bracket, lanced tabs towards bottom, on the bolts. 02085 COVER SEAL FIG. 3 4 SUPPORT POST (See Fig. 4) Use Hardware - - GROUP "C" CAUTION: Container support is spring loaded and locked to the cover. Handle cover assembly carefully so as not to unlatch the cover from the container support. 1. Rotate cover assembly onto its side as shown. 2. Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely. CARRIAGE BOLTS SUPPORT POST 02091 SELF TAPPING SHOULDER BOLTS 02461 LANCED TABS TOWARD BOTTOM FIG. 2B 7 LOCKNUTS FIG. 4