Poulan C36C User Manual - Page 9

7 CONTAINER MOUNTING (See Fig. 7) No hardware required 1. Install one container to left side first with warning to outside of unit. Install other container to right side. NOTE: Right container should always overlap left container at center support. 2. Close cover and lock latch handle over center support tube. COVER LATCH HANDLE CONTAINER WARNING WARNING CONTAINER HANDLE csDWruaobcAjnkeoecRtdt otNooprewIdrNeaaatmeGramagnoedwdd.eUer tsuieenrlioeonsraslytcioaonnr.etCaciohnmeecrmkisebnpadrgoepfdreerrqelyupielsanctelym. Reenpt lcaocnetawinheern. 02082 FIG. 7 CENTER SUPPORT TUBE CONTAINER WARNING 8 LOWER CHUTE (See Figs. 8A & 8B) Use Hardware - - GROUP "E" 1. Press weld nut into rubber latch and install two latch hook assemblies to lower chute using screw, washer, and lock washer as shown. 2. Tighten hardware securely. 3. Raise and hold deflector shield in upright position. 4. Place front of chute over front of mower deck opening and slide into place, as shown. 5. Hook front latch into latch bolt on front of mower deck. 6. Hook rear latch into latch bolt on back of mower deck. CAUTION: Do not remove discharge guard from mower. Raise and hold guard when attaching lower chute and allow it to rest on chute while in operation. LOCK WASHER LATCH WELD NUT WASHER WASHER LOCK WASHER LATCH FIG. 8A WELD NUT SCREW DEFLECTOR SHIELD FIG. 8B LATCH HOOKS 9 CHUTE LATCH ASSEMBLY (See Fig. 9) Use Hardware - - GROUPS "F & G" 1. Assemble latch pin to upper chute, as shown. 2. Press weld nut into rubber latch and assemble rubber latch to lower chute, as shown. 3. Tighten all hardware securely. #10 X 1-1/8" SCREW UPPER CHUTE WASHERS 3/16 X 3/4 X 16 GA. SPLIT SPACER ACORN NUT #10 X 5/8" SCREW LOWER CHUTE WASHER 3/16 X 3/4 X 16 GA. 02102 RUBBER LATCH WELD NUT LOCK WASHER FIG. 9 9