Poulan C42C User Manual - Page 7
See Figs. 1A, 1B & 1C
View all Poulan C42C manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
1 REAR MOUNTING BRACKET (See Figs. 1A, 1B & 1C) NOTE: If your tractor already has four (4) shoulder bolts installed on the rear drawbar, simply hang the mounting bracket, lanced tabs towards bottom, on the bolts. Discard hardware group "A" and disregard the remaining Step 1 instructions. If your tractor does not have four (4) shoulder bolts installed on the drawbar, follow the instructions below. LOCKNUTS BOLTS 02335 SHOULDER BOLTS 02337 LANCED TABS TOWARD BOTTOM FIG. 1A Use Hardware - - GROUP "A" Only one set of hardware in GROUP "A" will be used to mount the rear mounting bracket. To determine which set is correct for your tractor, check to see if there are (2) two upper corner ribs on each side of drawbar. If your tractor has the upper corner ribs, use the (4) four self tapping shoulder bolts. If your tractor does not have the corner ribs, use the set of (4) four bolts and locknuts. SELF TAPPING SHOULDER BOLTS (See Fig. 1B) 1. Using the four formed holes in the drawbar, install the four shoulder bolts as shown and tighten securely. 2. Hang the mounting bracket, lanced tabs towards bottom, on the bolts. UPPER CORNER RIBS SELF TAPPING SHOULDER BOLTS UPPER CORNER RIBS LANCED TABS TOWARD BOTTOM FIG. 1C 2 COVER SEAL (See Fig. 2) No hardware required 1. Align mark on seal with mark at cover opening. 2. Work seal into opening so cover sits between flanges of seal. ALIGNMENT MARKS 02085 COVER SEAL FIG. 2 3 SUPPORT POST (See Fig. 3) Use Hardware - - GROUP "B" CAUTION: Container support is spring loaded and locked to the cover. Handle cover assembly carefully so as not to unlatch the cover from the container support. 1. Rotate cover assembly onto its side as shown. 2. Assemble support post to container support with the three (3) carriage bolts and locknuts. Tighten securely. CARRIAGE BOLTS 02336 LANCED TABS TOWARD BOTTOM FIG. 1B BOLTS AND LOCKNUTS (See Fig. 1C) SUPPORT POST 1. Assemble the mounting bracket, lanced tabs towards bottom, using the four smaller inside holes on the drawbar. 2. Install the four bolts and locknuts as shown and tighten securely. 7 02091 FIG. 3 LOCKNUTS