ProForm 400 C Treadmill Uk Manual - Page 10
Identify the Gas Spring 83. Note that the Gas
View all ProForm 400 C Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
8. Have a second person raise and hold the treadmill Frame (36). Identify the Gas Spring (83). Note that the Gas Spring has a piston end and a cylinder end. See the two small inset drawings. Locate the Spring Clip (90) in the piston end of the Gas Spring. Using your fingernail or the end of a screwdriver, press on the end of the Spring Clip to loosen it, rotate the Spring Clip, and then pull the Spring Clip out of the Gas Spring. Be careful to avoid losing the Spring Clip. Note: Extra Spring Clips are included. Next, hold the piston end of the Gas Spring (83) near the bracket in the center of the Frame (36). Press the end of the Gas Spring as far as possible onto the ball on the bracket. See drawing 8a. Insert the Spring Clip (90) into the two indicated small holes in the piston end of the Gas Spring (83). Then, rotate the Spring Clip until it clips onto the Gas Spring. 8 Cylinder 83 36 Piston Bracket 90 8a 36 83 90 Holes 90 90 Bracket 9. Pivot the cylinder end of the Gas Spring (83) down to the position shown. Remove the Spring Clip (90) from the end of the Gas Spring. Next, align the cylinder end of the Gas Spring (83) with the bracket in the center of the Base (37). Press the end of the Gas Spring onto the ball on the bracket. Note: It may be necessary to pivot the Frame forward or backward slightly to align the end of the Gas Spring with the ball. See drawing 9a. Insert the Spring Clip (90) into the two indicated small holes in the Gas Spring (83). Then, rotate the Spring Clip until it clips onto the Gas Spring. With the help of a second person, lower the Frame (not shown) to the floor. 9 37 90 9a 83 Bracket 83 37 90 Holes Bracket 10