ProForm 400 Zlt Treadmill Uk Manual - Page 20
Power Cord.
View all ProForm 400 Zlt Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Locate the Reed Switch (62) and the Magnet (67) on the left side of the Pulley (64). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure 1/8 in. 64 that the gap between the Magnet and the Reed 38 Switch is about 1/8 in. (3 mm). If necessary, loosen the #8 x 3/4" Tek Screw (38), move the Reed Switch 62 67 slightly, and then retighten the Screw. Reattach the Motor Hood (not shown), and run the treadmill for a Top few minutes to check for a correct speed reading. View PROBLEM: The incline of the treadmill does not change correctly SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system. PROBLEM: The walking belt slows when walked on SOLUTION: a. If an extension cord is needed, use only a 3-conductor, 14-gauge (1 mm2) cord that is no longer than 5 ft. (1.5 m). b. If the walking belt is overtightened, treadmill performance may decrease and the walking belt may become damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is properly tightened. b 2-3 in. Idler Roller Bolts c. If the walking belt still slows when walked on, please see the front cover of this manual. 20