ProForm 450 Le Elliptical English Manual - Page 13
Attach the Left Front Arm Cover 20 and
View all ProForm 450 Le Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
14. Using a small plastic bag to keep your fingers clean, apply a generous amount of the included grease to the Pivot Axle (74) and to two Wave Washers (111). Insert the Pivot Axle (74) into the Upright (3) and center it. Slide a Wave Washer (111) onto each end of the Pivot Axle (74). Next, orient the Right Upper Body Leg (11) as shown, and slide it onto the right end of the Pivot Axle (74). Slide the Left Upper Body Leg (12) onto the left end of the Pivot Axle. At the same time, tighten an M8 x 23mm Screw (84) with an M8 Washer (88) into each end of the Pivot Axle (74). 14 84 88 12 111 3 111 11 Grease 74 88 84 15. Hold the Right Front Arm Cover (18) and the Right Rear Arm Cover (19) around the Right 15 Upper Body Leg (11). Attach the Arm Covers (18, 19) with three M4 x 32mm Round Head Screws (105); start all the Round Head Screws, and then tighten them. Attach the Left Front Arm Cover (20) and the Left Rear Arm Cover (21) in the same way. 20 21 19 18 105 11 13