ProForm 510 E Elliptical English Manual - Page 11
Tip: Avoid pinching the Upper Wire 110.
View all ProForm 510 E Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
6. Tip: Avoid pinching the Upper Wire (110). Avoid damaging the indicated plastic tabs. Set the Upright (4) on the Frame (1). Attach the Upright (4) with four M10 x 25mm Screws (92) and four M10 Split Washers (105). 6 Avoid pinching the Upper Wire (110) and avoid damaging the tabs 4 92 110 105 92 1 105 Tabs 7. Using a plastic bag to keep your fingers clean, apply some of the included grease to the Pivot Axle (35) and to two 16mm Wave Washers (54). Insert the Pivot Axle (35) through the Upright (4) and center it. Tip: It may be helpful to use a rubber mallet. Identify the Right Upper Body Leg (60) and orient it as shown. Slide a 16mm Wave Washer (54) and the Right Upper Body Leg (60) onto the right side of the Pivot Axle (35). Repeat these actions for the Left Upper Body Leg (46). Tighten an M8 x 13mm Screw (82) and an M8 Washer (97) into each end of the Pivot Axle (35) at the same time. 7 46 4 35 Grease 54 60 97 82 11