ProForm 615 User Manual - Page 2
Part List°model No. Petl61591, Table Of Contents, Important Precautions, Warning - t treadmill
View all ProForm 615 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
¨ TABLE OF CONTENTS IMPORTANT PRECAUTIONS 2 BEFORE YOU BEGIN 5 ASSEMBLY 6 OPERATION AND ADJUSTMENT 8 HOW TO FOLD AND MOVE THE TREADMILL 19 TROUBLE-SHOOTING 20 CONDITIONING GUIDELINES 22 PART LIST 23 HOW TO ORDER REPLACEMENT PARTS Back Cover Note: An EXPLODED DRAWING is attached in the centre of this manual. IMPORTANT PRECAUTIONS WARNING: To reduce the risk of burns, fire, electric shock, or injury to persons, read the following important precautions and information before operating the treadmill. 1. It is the responsibility of the owner to ensure that all users of this treadmill are adequately informed of all warnings and precautions. 6. Do not operate the treadmill where aerosol products are used or where oxygen is being administered. 2. Use the treadmill only as described in this manual. 7. Keep children under the age of 12 and pets away from the treadmill at all times. 3. Place the treadmill on a level surface, with 2 m (eight feet) of clearance behind it. Do not place the treadmill on any surface that blocks air openings. To protect the floor or carpet from damage, place a mat under the treadmill. 8. The treadmill should not be used by persons weighing more than 115 kg (250 pounds). 9. Never allow more than one person on the treadmill at a time. 4. When choosing a location for the treadmill, make sure that the location and position permit access to a plug. 5. Keep the treadmill indoors, away from moisture and dust. Do not put the treadmill in a garage or covered patio, or near water. 10. Wear appropriate exercise clothing when using the treadmill. Do not wear loose clothing that could become caught in the treadmill. Athletic support clothes are recommended for both men and women. Always wear athletic shoes. Never use the treadmill with bare feet, wearing only stockings, or in sandals. 2 PART LISTÑModel No. PETL61591 R1000A To locate the parts listed below, refer to the EXPLODED DRAWING attached in the centre of this manual. Key No. Qty. Description Key No. Qty. Description Key No. Qty. Description 1 1 Motor Belt 50 1 Book Holder 102 1 Lock Knob 2 1 Pulley/Flywheel/Fan 51 1 Front Belly Pan 103 2 Extension Leg 3 4 Motor Nut 52 1 Power Supply 104 2 Extension Leg Cap 4* 1 Motor/Pulley/ 53 4 Cable Tie Clamp 105 1 Shock Flywheel/ Fan 54 4 Cable Tie 106 1 Choke 5 1 Incline Motor Bolt 55 1 Walking Belt 107 2 Pulse Bar Bolt 6 1 Plastic Incline Motor 56 1 24Ó Wire Harness 108 2 Pulse Bar Washer Spacer 57 1 Rear Roller 109 1 Pulse Bar 7 1 Incline Motor 58 1 Belly Pan Spacer 110 2 Handrail Foam Grip 8 1 Stop Bracket 59 2 Rear Foot 111 1 Lock Knob Sleeve 9 1 Small Nut 60 1 Rear Foot Screw 112 1 Spring 10 2 Star Washer 61 1 Ground Wire 113 1 Lock Pin Collar 11 1 Optic Switch 62 13 Ground Wire Screw 114 1 Pin Clip 12 1 Frame 63 1 Belly Pan 115 1 Lock Pin 13 1 Optic Switch Bolt 64 1 Rear Endcap 116 1 Console Base Bottom 14 1 Incline Optic Disk 65 2 Rear Roller Adj. Bolt 117 2 Upright Endcap 15 8 Incline Motor Nut 66 1 Motor 118 1 Motor Sleeve 16 2 Hood Screw 67 1 Latch Decal 119 8 Hood Bracket Screw/ 17 4 Plastic Stand-off 68 4 Platform Screw Incline Shield Screw 18 2 Hood Bracket (Short) 69 3 Electronics Screw 120 1 Rear Foot Spacer 19 1 Hood Bracket (Long) 70 1 Latch Catch 121** 1 Hand Weight Set 20 2 Warning Decal 71 1 Walking Platform 122 1 Long Incline Motor Bolt 21 1 Reed Switch 72 5 8Ó Cable Tie 123 2 Static Warning 22 1 Reed Switch Clip 73 1 Jack 124 1 Hand Pulse Wire 23 1 Motor/Controller Wire 74 1 Motor Tension Bolt 125 1 Motor/Choke Bracket 24 1 Controller 75 2 Foot Rail Insert 126 1 Filter 25 1 Electronics Bracket 76 14 Screw 127 1 UK Power Cord 26 1 Circuit Breaker 77 1 Console 128 1 Euro Power Cord 27 1 Receptacle 78 1 Motor Isolator Plate 129** 1 Chest Pulse Sensor 28 1 Extension Leg Assm. 79 4 Long Screw 130** 1 Chest Pulse Sensor 29 1 On/Off Switch 80 1 10Õ I-Fit Wire Strap 30 1 Inlet Bracket 81 4 Motor Star Bushing # 1 15Ó Wire Harness 31 1 Incline Leg 82 1 Upright # 1 8Ó White Wire, 2F 32 2 Frame Pivot Bolt 83 2 Incline Leg Pivot Bolt # 1 14Ó White Wire, 2F 33 2 Frame Pivot Spacer 84 2 Side Hood Screw # 1 8Ó Black M/F 34 1 Upright Wire Harness 85 2 Handrail Extension # 1 8Ó Blue Wire, 2F 35 1 Front Roller Adj. Bolt 86 2 Wheel Bolt # 1 4Ó Blue Wire, 2F 36 3 Roller Adj. Washer 87 1 Console Base # 1 4Ó Black Wire, 2F 37 2 Motor Tension Nut/ 88 1 Motor Tension Washer # 1 6Ó Green Wire, F/Ring Front Roller Nut 89 10 Console/Catch Screw # 1 8Ó Green Wire, F/Ring 38 4 Motor Bolt 90 1 Key/Clip # 1 8Ó Green Wire, 2 Ring 39 2 Cap Screw 91 1 Incline Motor Plate # 1 14Ó Blue 2F 40 1 Left Foot Rail Cap 92 1 Right Foot Rail Cap # 1 25Ó Wire Harness 41 2 Foot Rail 93 1 Motor Tension Spacer # 1 User's Manual 42 1 Front Roller/Pulley 94 1 Motor Hood 43 1 Magnet 95 2 Front Wheel * Includes all parts shown in the 44 2 Platform Screw (Mid) 96 1 Incline Motor Shield box 45 2 Isolator 97 4 Thick Base Pad **For more information about the op- 46 4 Isolator Screw 98 1 12Ó Audio Wire tional hand weight set, see page 47 15 Plastic Fastener 99 1 Upright Grommet 18 48 1 Shield 49 2 Belt Guide 100 1 Allen Wrench 101 11 Short Screw # These parts are not illustrated 23