ProForm 700 Uk Manual - Page 9

7. The Console (16) can use four AA batteries (not included); alkaline batteries are recommended. 7 IMPORTANT: If the Console has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries. Otherwise, you may damage the console displays or other electronic compo- nents. Remove the battery cover, insert the bat- teries into the battery compartment, and reat- tach the battery cover. Make sure to orient the batteries as shown by the diagram inside the battery compartment. Battery Cover Batteries 16 8. Attach the Pivot Bracket (53) to the Upright (13) with the Pivot Clamp (54) and the Pivot Handle (55). Note: The Pivot Handle (55) functions like a ratchet. Turn the Pivot Handle clockwise, pull it away from the Upright (13), turn it counterclockwise, push it toward the Upright, and then turn it clockwise again. Repeat this process until the Pivot Handle is tight. While a second person holds the Console (16) near the Upright (13), insert the console wire through the Pivot Bracket (53) and connect it to the Extension Wire (23). Then, insert the excess wire downward into the Upright. Tip: Avoid pinching the wires. Attach the Console (16) to the Pivot Bracket (53) with four M6 x 15mm Button Screws (46). 8 Avoid pinching the wires 16 23 13 46 46 Console Wire 53 54 55 9. Attach the Left and Right Pivot Covers (50, 51) around the Upright (13) with an M4 x 15mm 9 Round Head Screw (58) and two M5 x 15mm Round Head Screws (59). 51 59 50 59 13 58 9