ProForm 735 Ekg Bike Uk Manual - Page 5

1. Identify the Front Stabiliser (2). Whilst another person lifts the front of the Frame (1) slightly, attach the Front 1 65 50 Stabilizer to the Frame with two M10 x 65mm Carriage Bolts (65) and two M10 Black Nylon Locknuts (63). Make sure that the Front Stabiliser is turned so the 50 Wheels (50) are not touching the floor. 2. Whilst another person lifts the back of the Frame (1) slightly, attach a Rear Stabiliser (62) to the Frame with 2 two M10 x 65mm Carriage Bolts (65) and two M10 Black Nylon Locknuts (63). 2 1 63 63 62 63 1 3. Whilst another person holds the Upright (13) in the 3 position shown, connect the Upper Wire Harness (36) to the Lower Wire Harness (43). Slide the Upright (13) onto the Frame (1). Be careful to avoid pinching the Wire Harnesses (36, 43). Attach the Upright to the Frame with three M8 x 25mm Button Screws (14) and three M8 Split Washers (64). Attach the Water Bottle Holder (6) to the Upright (13) with two M4 x 22mm Screws (53). 65 6 13 53 14 64 14 36 43 64 14 1 4. The Console (16) requires four "D" batteries (not 4 included); alkaline batteries are recommended. Remove the screw from the battery drawer. Pull the battery drawer open and insert four batteries. Make sure that the batteries are oriented as shown by the markings inside the battery drawer. Close the battery drawer and reattach the screw. Note: When the batteries are installed correctly, the fan will turn on for a moment. 16 Batteries Screw 5 Battery Drawer