ProForm 755 Ekg Bike Uk Manual - Page 7
Console to the Upper Wire Harness 42. Insert
View all ProForm 755 Ekg Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
5. The Console (4) requires four 1,5V "D" batteries; alka- 5 line batteries are recommended. Remove the indicated screw from the battery drawer, and pull the battery drawer open. Insert four batteries into the battery drawer; make sure that the batteries are oriented as shown by the markings inside the battery drawer. Close the battery drawer and reattach the screw. 4 Batteries Screw 6. While another person holds the Console (4) in the position shown, connect the wire harness on the Console to the Upper Wire Harness (42). Insert the excess wire harness down into the Upright (2). Attach the Console (4) to the Upright (2) with four M4 x 16mm Screws (57). Be careful to avoid pinching the wire harnesses. Battery Drawer 6 57 57 2 4 42 Wire Harness 7. Remove the packing tube from the Frame (1). Turn the 7 Seat Knob (20) counterclockwise two or three turns to loosen it. Next, pull the Seat Knob and insert the Seat Post (8) into the Frame. Release the Knob, and move the Seat Post up and down slightly until the pin on the Knob snaps into one of the holes in the Seat Post. Then, turn the Knob clockwise until it is tight. Tighten an M6 x 8mm Screw (58) into one end of the plate on the Seat Post (8). Next, slide the Seat Bracket (6) onto the Seat Post, and tighten the Seat Handle (24) into the Seat Bracket. Then, tighten another M6 x 8mm Screw (58) into the other end of the plate on the Seat Post. Attach the Seat (9) to the Seat Bracket (6) with four M8 Nylon Locknuts (65) and four M8 Split Washers (50). Note: The Nylon Locknuts and Split Washers are preattached to the Seat. 7 9 24 6 58 50 65 20 1 8 Packing Tube