ProForm 870e English Manual - Page 13

4 33 35 22 View from the Front HOW TO ADJUST THE DRIVE BELT The exercise cycle features a Drive Belt (1) that must be kept properly adjusted. If the Drive Belt slips as you pedal, it should be adjusted. To do this, the left side shield and the flywheel cover must be removed. Refer to the instructions on page 12 and remove these parts. View from the Back 1 1 Next, locate the Reed Switch (4). Turn the arms of the Crank (22) until the Magnet (33) is aligned with the Reed Switch. Loosen but do not remove the indicated Screw (35). Slide the Reed Switch slightly closer to or away from the Magnet. Retighten the Screw. Turn the Crank for a moment. Repeat until the console displays correct feedback. When the Reed Switch is correctly adjusted, reattach the left side shield, flywheel cover and left pedal. Top 45 Middle 45 Bottom 45 Next, locate the Drive Belt (1). To tighten the Drive Belt, first loosen the top and bottom 3/8" Locknuts (45). Next, turn the middle 3/8" Locknut (45) slightly; be careful not to overtighten the Drive Belt. When the Drive Belt is properly adjusted, tighten the top and bottom 3/8" Locknuts (45). Reattach the left side shield, flywheel cover, and left pedal. 13