ProForm 870e English Manual - Page 5

ASSEMBLY Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench , a phillips screwdriver wrenches . and two adjustable 1. As you attach the Handlebar Post (19), be careful not to pull on the Resistance Cable (6). If the Resistance Cable is pulled further out of the Frame (13), it will be very difficult to push it back in. The Handlebar Post will then be difficult to assemble and the resistance knob may not function properly. Hold the Handlebar Post (19) near the Frame (13) as shown. Feed the Resistance Cable (6) and the Reed Switch Wire (4) into the Frame, and then slide the Handlebar Post into the Frame. Be careful not to pinch the Resistance Cable or the Reed Switch Wire. Attach the Handlebar Post with three M10 x 22mm Button Head Bolts (55) and three M10 Lock Washers (61). The Console (5) requires two 1.5-volt batteries (not included). Alkaline batteries are recommended. Refer to the inset drawing. Locate the battery door on the back of the Console. Slide the battery door to the left and open it as shown. Press two batteries into the battery clip, with the negative (-) ends of the batteries touching the springs. Close the battery door and slide it to the right. 2. Make sure that there are Adjustable Endcaps (25) on the ends of the Front Stabilizer (27). Hold the Front Stabilizer (27) against the saddle on the front of the Frame (13). Make sure that the Front Stabilizer is turned so the Wheels (26) are not touching the floor. The Wheels should not touch the floor unless the exercise bike is tipped for moving. Attach the Front Stabilizer with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44). 1 4 6 61 55 2 54 26 25 5 19 55 Battery 5 Door 61 55 Batteries 13 Battery Clip 26 25 27 13 44 3. Make sure that there are Round Endcaps (15) on 3 the ends of the Rear Stabilizer (16). Hold the Rear Stabilizer (16) against the saddle on the rear of the Frame (13), with the square holes facing away from the saddle. Attach the Rear Stabilizer with two M10 x 75mm Carriage Bolts (54) and two M10 Nylon Locknuts (44). 44 13 15 16 15 Square Holes 54 5