ProForm 900 Elliptical Uk Manual - Page 9
Wire Harness 48
View all ProForm 900 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Orient the Rear Frame Cover (23) as shown. While a second person tips the elliptical exercis- 7 er forward, attach the Rear Frame Cover to the Base (1) with four M4 x 65mm Screws (91) and two M4 x 16mm Self-tapping Screws (79). 23 79 1 91 8. Have a second person hold the Upright (6) near the Frame (2) as shown. Pull the Wire Harness (48) out of the Frame (2) and insert it upward through the Upright (6). Tip: Use a piece of tape or an elastic band to hold the Wire Harness in place until step 14. Insert the Upright (6) into the Frame (2). Tip: Start all screws before tightening any of them. Attach the Upright with three M8 x 16mm Patch Screws (95). Avoid pinching the Wire Harness (48) between the Upright and the Frame. 8 48 95 Avoid pinching the Wire Harness (48) during this step 6 2 95 9. Apply a generous amount of grease to the Pivot Axle (65) and insert it into the Frame (2). Orient the two Frame Covers (17) as shown. Attach the Frame Covers to the Frame (2) with four M4 x 16mm Screws (86). 9 86 17 9 2 17 Grease 65 86