ProForm 940 Ce Elliptical English Manual - Page 10

7. Identify the Right Link Arm (10). Apply a small amount of grease to the axles on the Right Link Arm and to two 5/8" Wave Washers (102). Then, slide a Pivot Spacer (71) and a Wave Washer onto each axle. At the same time, slide the Right Link Arm (10) into the right Upper Body Arm (12) and into the Right Pedal Arm (8). Attach the Right Link Arm (10) to the right Upper Body Arm (12) with a 5/16" x 1" Screw (81), a Large Axle Cover (94), and a 5/16" Washer (104). Then, attach the Right Link Arm (10) to the Right Pedal Arm (8) with a 5/16" x 1" Screw (81), a Small Axle Cover (67), and a 5/16" Washer (104). Repeat this step for the other side of the elliptical. Tip: If you have a hard time working the Link Arms (10, not shown) all the way into the Upper Body Arms (12) and the Pedal Arms (8, not shown), try working them in halfway and then tightening the 5/16" x 1" Screws (81) to pull them the rest of the way in. 7 12 81 67 104 104 81 94 Grease 102 71 71 102 8 Grease 10 8. While a second person holds the Console (60) near the Upright (6), connect the console wire to the Upper Wire Harness (97). Then, connect the console pulse wire to the Hand Pulse Wire (65). Insert the excess wire downward into the Upright. Tip: Avoid pinching the wires during this step. Attach the Console (60) to the Upright (6) with four #8 x 3/4" Screws (78). 8 60 Console Wire 97 Pulse Wire 65 6 Avoid pinching the wires 78 10