ProForm 955r Bike English Manual - Page 5

1. Carefully slide the Upright (6) onto the Frame (1). Be careful to avoid pinching the wires. Loosely thread four M10 x 25mm Button Screws (71) with M10 Split Washers (17) through the Upright and into the Frame. Attach the top of the side shields with two M4 x 16mm Screws (21). Firmly tighten all four Button Screws in the following order: front, rear, and then sides. 1 6 Front Side 71 17 Side 21 17 71 Rear 21 1 2. While another person holds the Handlebar (16) near the Upright (6), route the Reed Switch Wire (18) up through the indicated hole in the Handlebar. Attach the Handlebar (16) to the Upright (6) with two M10 x 25mm Button Screws (71) and two M10 Split Washers (17). Make sure that no wires are pinched between the Handlebar and the Upright. Next, attach the Tension Control (22) to the Upright (6) with an M4 x 16mm Screw (21). 2 6 18 16 22 21 3. The Console (9) requires two "AA" batteries (not included). Alkaline batteries are recommended. To install batteries, turn the console over and insert two batteries into the battery clip as shown in the inset drawing. Make sure that the negative ends of the batteries (marked "-") are touching the springs in the battery clip. Attach the Console (9) to the Console Back (30) with four Console Screws (35), making sure that the indicated wires are extending from the Console Back (30). Be careful not to pinch the wires. 3 9 30 Hole 17 71 Batteries Battery Clip Wires 35 5