ProForm C830 English Manual - Page 20
Maintenance And Troubleshooting - elliptical parts
View all ProForm C830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
MAINTENANCE AND TROUBLESHOOTING Inspect and tighten all parts of the elliptical crosstrainer regularly. Replace any worn parts immediately. For smooth opera- tion of the elliptical crosstrainer, clean the ramp regularly using a soft cloth and a small amount of mild detergent. Ramp Other parts of the elliptical crosstrainer can be cleaned in the same way. Keep liquids away from the console. Never use abra- sives or solvents. HOW TO MOVE THE ELLIPTICAL CROSSTRAINER Stand in front of the elliptical crosstrainer, hold the handle- bars firmly, and place one foot against the ramp in the location shown. Pull the handlebars until Place your foot here the elliptical crosstrainer can be moved on the front wheels, and carefully move the ellipti- Wheel cal crosstrainer to the desired location. Then, place one foot against the ramp and lower the ellipti- cal crosstrainer. Due to the size and weight of the elliptical crosstrainer, use extreme caution while moving and lowering it. HOW TO LEVEL THE ELLIPTICAL CROSSTRAINER After the elliptical crosstrainer has been moved, make sure that the ends of both stabilizers are touching the floor. If the elliptical crosstrainer rocks slightly during use, Leveling Foot turn one or both of the leveling feet under the front stabilizer until the rocking motion is eliminated. HANDGRIP PULSE SENSOR TROUBLESHOOTING If there are sheets of clear plastic on the metal contacts on the handgrip pulse sensor, peel off the plastic. For optimal performance of the handgrip pulse sensor, keep the metal contacts clean using a soft cloth and a small amount of mild detergent. Never use alcohol, abrasives, or chemicals. Avoid moving your hands or squeezing the handgrip pulse sensor too tightly. Excessive movement or pressure may interfere with heart rate readings. For the most accurate heart rate reading, hold the metal contacts for about 30 seconds. 20