ProForm C830 English Manual - Page 6
M10 x 112mm Carriage Bolts 34 and two M10 Nylon
View all ProForm C830 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
1. Identify the Front Stabilizer (3). While another person lifts the front of the Frame (1), attach the Front 1 32 Stabilizer to the Frame with two M10 x 112mm 34 Carriage Bolts (34) and two M10 Nylon Locknuts (106). Make sure that the Front Stabilizer is turned so the Wheels (32) are not touching the floor. 32 2. While another person lifts the back of the Frame (1), attach the Rear Stabilizer (4) to the Frame with two M10 x 112mm Carriage Bolts (34) and two M10 Nylon Locknuts (106). 3. Identify the Frame Axle (104), which is the longest axle. Slide an M8.5 Washer (45) and a Ramp Cap (102) onto an M8 x 19mm Patch Screw (108). Tighten the Patch Screw into one end of the Frame Axle (104). Next, apply a small amount of the included grease to the Frame Axle. Locate the two Frame Bushings (103) in the Frame (1). Press a Ramp Shield (18) onto each Frame Bushing. Next, align the indicated tubes on the Ramp (59) with the Ramp Shields. Make sure that the Ramp is turned as shown. Insert the Frame Axle (104) into the Ramp, the Ramp Shields, and the Frame Bushings. Note: It may be helpful to use a rubber mallet to insert the Frame Axle. Slide an M8.5 Washer (45) and a Ramp Cap (102) onto an M8 x 19mm Patch Screw (108). Tighten the Patch Screw into the other end of the Frame Axle (104). 4. Identify the Incline Axle (100), which is the longest remaining axle. Slide an M6 Large Washer (94) onto an M6 x 16mm Button Screw (109). Tighten the Button Screw into one end of the Incline Axle (100). Next, apply a small amount of grease to the Incline Axle. Raise the Ramp (59). Insert the Incline Axle (100) through one side of the Ramp, through a Ramp Spacer (99), through the end of the Incline Motor (82), through another Ramp Spacer (99), and then through the other side of the Ramp. Slide an M6 Large Washer (94) onto an M6 x 16mm Button Screw (109). Tighten the Button Screw into the other end of the Incline Axle (100). 3 1 106 2 106 106 1 4 34 3 59 Tubes 102 45 108 18 Grease 102 108 45 104 1 18 103 4 99 59 Grease 94 82 100 109 94 109 6