ProForm Crosswalk Zxt4 Treadmill English Manual - Page 10
do not fully
View all ProForm Crosswalk Zxt4 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
5. Hold the Right Upright (33) against the Base (74). Be careful not to pinch the Upright 5 Wire (63). Insert a 3/8" x 3 1/4" Screw (2) with a 3/8" Star Washer (3) into the top hole in the Right Upright (33). Then, partially tighten the Screw into the Base (74). Partially tighten two more 3/8" x 3 1/4" Screws (2) with two 3/8" Star Washers (3) into the Right Upright (33) and the Base (74); do not fully tighten the Screws yet. Attach the Left Upright (not shown) in the same way. Note: There are no wires on the left side. 6. Identify the Right Handrail (64). Have a second person hold the Right Handrail near the Right 6 Upright (33). Route the Upright Wire (63) into the bottom of the Right Handrail (64) and out of the hole in the Right Handrail. Be careful not to pinch the Upright Wire (63). Partially tighten a 5/16" x 3/4" Screw (5) with a 5/16" Star Washer (6) into the Right Upright (33) and the Right Handrail (64). Then, partially tighten a 5/16" x 3" Screw (7) with a 5/16" Star Washer (6) into the Right Handrail and the Right Upright; do not fully tighten the Screws yet. Attach the Left Handrail (not shown) in the same way. Note: There are no wires on the left side. 33 63 74 3 2 3 7 6 64 6 5 63 33 7. Set the console assembly face down on a soft surface to avoid scratching the console assembly. Remove the two screws (C) from the Console Crossbar (61), and then remove the Console Crossbar. Discard the screws. 7 C 61 C Console Assembly 10