ProForm Fx5 Elliptical English Manual - Page 6

1. To make assembly easier, read the 1 information on page 5 before you begin assembling the elliptical exerciser. Attach a Wheel (8) to one side of the Frame (1) with an M10 x 35mm Shoulder Screw (57). Attach the other Wheel in the same way. 1 8 57 2. Apply a generous amount of the included grease to the Pivot Axle (41). Then, insert the Pivot Axle through the Frame (1). Apply a small amount of grease to a 16mm Wave Washer (66). Slide the Wave Washer onto the right side of the Pivot Axle (41). 2 23 Identify the Right Upper Body Arm (37), which is marked with an "R" sticker. Slide the Right Upper Body Arm onto the Pivot Axle (41). Attach the Right Upper Body Arm with an M8 x 25mm Button Screw (77), a Pivot Axle Cover (44), and an M8 x 25mm Washer (54). Attach the Left Upper Body Arm (23) in the same way. 1 Grease 41 66 37 54 44 77 3. Orient the Water Bottle Holder (6) as shown. 3 Hold the Water Bottle Holder near the Frame (1) and insert the Wire Harness (73) upward through the Water Bottle Holder. Next, slide the Water Bottle Holder (6) onto the Frame (1). Attach the Water Bottle Holder with two M4 x 35mm Screws (74). 73 6 74 1 6