ProForm Fx5 Elliptical English Manual - Page 7

4. Orient the Upright Cover (5) and the Upright (3) 4 as shown. While another person holds the Upright Cover and the Upright near the Frame (1), insert the Wire Harness (73) upward through the Upright Cover and the Upright. Tip: Use an elastic band or a piece of tape to pre- vent the Wire Harness from falling into the Upright. Tip: Avoid pinching the Wire Harness (73) during this step. Insert the Upright (3) through the Upright Cover (5) into the Frame (1). Then, slide the Upright Cover upward and attach the Upright to the Frame with three M8 x 16mm Button Screws (53). Tip: Start all the Button Screws before tightening them. 73 5 53 3 Avoid pinching the Wire Harness (73) during this step 53 1 53 5. The Console (4) requires four 1.5V "D" batteries 5 (not included); alkaline batteries are recom- mended. IMPORTANT: If the elliptical exercis- er has been exposed to cold temperatures, allow it to warm to room temperature before inserting batteries into the Console. If you do not do this, the console displays or other electronic components may become dam- aged. Remove the two screws from the back of the console, and remove the battery cover. Insert four batteries into the Console. Orient the batteries as shown by the markings inside the battery compartment. Then, reattach the battery cover. Note: The Console (4) can be operated with an optional power supply instead of batteries. To purchase a power supply, call the telephone number on the front cover of this manual. Plug one end of the power supply into the jack on the Console. Plug the other end of the power supply into an appropriate outlet that is properly installed in accordance with all local codes and ordinances. Batteries 4 Screws Battery Cover Batteries 7