ProForm Performance 400i Instruction Manual - Page 10
Upright Wire 81.
View all ProForm Performance 400i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 10 highlights
6. Attach a Handrail (84) to the Right Upright (90) with a 5/16" x 2 1/2" Screw (28) and a 5/16" Star Washer (11) in the location shown. Make sure not to pinch the Upright Wire (81). Do not fully tighten the Screw yet. Then, remove and discard the two indicated screws (E). 6 28 11 E 84 89 Attach the other Handrail (not shown) to the Left Upright (89) in the same way. Note: There 81 are no wires on the left side. 90 7. IMPORTANT: To avoid damaging the Pulse Crossbar (93), do not use power tools and do 7 not overtighten the #10 x 3/4" Screws (9). Orient the Pulse Crossbar (93) as shown. Attach the Pulse Crossbar to the Handrails (84) with four #10 x 3/4" Screws (9) and four #10 Star Washers (5); start all four Screws, and then tighten them. Make sure not to pinch the Upright Wire (81). 28 11 9 5 28 Next, tighten two 5/16" x 2 1/2" Screws (28) with two 5/16" Star Washers (11) into the Pulse Crossbar (93) as shown. 84 Firmly tighten the four 5/16" x 2 1/2" Screws (28). Then, remove the wire tie (A) from the Upright Wire (81). 93 81 84 A 28 11 9 5 28 10