ProForm Performance 400i Instruction Manual - Page 16
Make sure that all parts are properly tightened before you use the treadmill., start all four Screws
View all ProForm Performance 400i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
18. Attach the Tablet Holder (25) to the console assembly (F) with four #8 x 5/8" Machine Screws 18 (8); start all four Screws, and then tighten them. Do not overtighten the Screws. 25 8 8 F 19. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see pages 27 and 28). Note: Extra hardware may be included. 16
16
19.
Make sure that all parts are properly tightened before you use the treadmill.
If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure
place; the hex key is used to adjust the walking belt (see pages 27 and 28). Note: Extra hardware may be
included.
18. Attach the Tablet Holder (25) to the console
assembly (F) with four #8 x 5/8" Machine Screws
(8);
start all four Screws, and then tighten
them. Do not overtighten the Screws.
18
8
F
8
25