ProForm Performance 900i Treadmill English Manual - Page 12

6. Attach a Handrail (84) to the Right Upright (90) with a 5/16" x 2 1/2" Screw (28) and a 5/16" Star Washer (11) in the location shown. Make sure not to pinch the Upright Wire (81). Do not fully tighten the Screw yet. Attach the other Handrail (not shown) to the Left Upright (89) in the same way. Note: There are no wires on the left side. 6 28 11 E 84 89 Then, remove and discard the two indicated screws (E) from each Handrail (84) (only one Handrail is shown). 81 90 7. IMPORTANT: To avoid damaging the Pulse Crossbar (93), do not use power tools and do 7 not overtighten the #10 x 3/4" Screws (9). Orient the Pulse Crossbar (93) as shown. Attach the Pulse Crossbar to the Handrails (84) with four #10 x 3/4" Screws (9) and four #10 Star Washers (5); start all four Screws, and then tighten them. Make sure not to pinch the Upright Wire (81). 28 11 9 5 28 Tighten two 5/16" x 2 1/2" Screws (28) with two 5/16" Star Washers (11) into the Pulse Crossbar (93) as shown. 84 Next, firmly tighten the four 5/16" x 2 1/2" Screws (28). Then, remove the wire tie (A) from the Upright Wire (81). 93 81 84 A 28 11 9 5 28 12