ProForm Power 595i Uk Manual - Page 15
IMPORTANT: The Tablet Holder 99 is
View all ProForm Power 595i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
16. Firmly tighten the four 3/8" x 2 3/8" Screws (7), the two 3/8" x 1 3/4" Screws (62), and the 16 two 3/8" x 1 1/4" Screws (63). Next, set the Left Inner Base Cover (50) onto the lower end of the Left Upright (89). Slide the Left Base Cover (82) downward and press it onto the Left Inner Base Cover. Then, set the Right Inner Base Cover (51) onto the lower end of the Right Upright (90). Slide the 83 Right Base Cover (83) downward and press it onto the Right Inner Base Cover. 89 82 50 63 7 62 51 62 63 90 7 17. P ress the two tabs (not shown) on the Tablet Holder (99) into the slots (M) in the console assembly (G). Then, attach the Tablet Holder (99) with four M4 x 16mm Machine Screws (97). Tip: Start the two upper Machine Screws first, and then start the two lower Machine Screws. Do not overtighten the Machine Screws. IMPORTANT: The Tablet Holder (99) is designed for use with most full-size tablets. Do not place any other electronic device or object in the Tablet Holder. 17 Start First 97 99 97 MG 18. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the treadmill. To avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex key in a secure place; the hex key is used to adjust the walking belt (see page 26 and 27). Note: Extra hardware may be included. 15