ProForm Style 4500 Treadmill Uk Manual - Page 10

10. Have a second person raise and hold the treadmill Frame (51). Identify the Gas Spring (98). Note that the Gas Spring has a cylinder end and a rod end. See the two small inset drawings. Locate the Spring Clip (96) in the rod end of the Gas Spring. Using your fingernail or the end of a screwdriver, press on the end of the Spring Clip to loosen it, rotate the Spring Clip, and then pull the Spring Clip out of the Gas Spring. Be careful to avoid losing the Spring Clip. Note: Extra Spring Clips are included. Next, hold the rod end of the Gas Spring (98) near the bracket in the center of the Frame (51). Press the end of the Gas Spring as far as possible onto the ball on the bracket. See the lower inset drawing. Insert the Spring Clip (96) into the two indicated small holes in the rod end of the Gas Spring (98). Then, rotate the Spring Clip until it clips onto the Gas Spring. 10 Cylinder 98 51 Rod Bracket 96 51 98 96 Holes 96 96 Bracket 11. Pivot the cylinder end of the Gas Spring (98) down to the position shown. Remove the Spring Clip (96) from the end of the Gas Spring. Next, align the cylinder end of the Gas Spring (98) with the bracket in the center of the Base (52). Press the end of the Gas Spring onto the ball on the bracket. Note: It may be necessary to pivot the Frame (not shown) forward or backward slightly to align the end of the Gas Spring with the ball. See the lower drawing. Insert the Spring Clip (96) into the two indicated small holes in the Gas Spring (98). Then, rotate the Spring Clip until it clips onto the Gas Spring. With the help of a second person, lower the Frame (not shown) to the floor. 11 52 96 52 96 Holes 98 Bracket 98 Bracket 10