ProForm Trainer 420 Treadmill Canadian English Manual - Page 9
If The Connectors Are Not Con
View all ProForm Trainer 420 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
7. Set the Console Assembly (91) face down on a 7 soft surface to avoid scratching it. Hold the Right Console Handrail (33), which has a large hole in one side, near the Console Assembly. Wire 85 Tie Next, insert the console wire and the tie into the Bracket 7 10 hole in the side of the Right Handrail (33). Using needlenose pliers, pull the console wire out of the hole near the bracket on the Right Handrail. Then, set the Right Handrail (33) on the Console Large 33 Hole Assembly (91). Make sure that no wires are pinched. Finger tighten an M5 x 16mm Screw 91 (85) with an M5 Star Washer (7) into the Right Handrail, and then finger tighten two M4.2 x 19mm Screws (10) into the Right Handrail. Tighten the M5 x 16mm Screw and then the two M4.2 x 19mm Screws; do not overtighten the Screws. Attach the Left Handrail (not shown) to the Console Assembly (91) in the same way. Note: There are no wires on the left side. 8. Remove the plastic ties from the Right Handrail (33) and the Left Handrail (not shown). With the help of a second person, hold the Console Assembly (91) near the Right Upright (54). Remove the wire tie from the Wire Harness (39). Connect the Wire Harness to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If they do not, turn one connector and try again. IF THE CONNECTORS ARE NOT CONNECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Insert the connectors and the excess wire downward into the Right Upright (54). 8 39 54 91 33 Console Wire Wire Tie Console Wire 39 9. Attach the Console Assembly (91) to the Right 9 Upright (54) and the Left Upright (53) with four 91 M8 x 15mm Bolts (8) and four M8 Star Washers (5). Do not tighten the Bolts yet. Make sure that no wires are pinched. 8 5 54 9 8 5 53