Pyle UPMXAKB2000 Instruction Manual - Page 4
Getting Connected
View all Pyle UPMXAKB2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Getting Connected Ampli er, Mixer and External Sound System Connections Music and Vocals The unit's LINE OUT (RCA) jacks can be used to connect to a second power amplifier, an external sound system or mixing device. Note: The unit offers optimum performance when used as an amp for home sound systems and smaller performance systems and speakers. Use L/R RCA audio cables to connect to an ampli er, mixer or other external sound system. Connect from the L/R LINE OUTPUT on the unit to the L/R audio input on your amp, mixer or sound system. Digital Karaoke Mixing Amplifier with Key Control Outputting Vocals Independently You can output vocals independently from the unit into a mixer from the L/R RCA MIC Outputs. Connect the L/R RCA cable from the MIC OUTPUT to an Audio Input on your mixer. External Speaker Connection You can directly connect to speakers using either MDP (banana plug) speaker cables or standard speaker wires. Be sure to correctly match the polarities (+/-). Connect rated speakers no lower than 4-0hms to the unit. Please do not try to connect more than one speaker per channel, as the load may exceed the ampli ers handling capacity, causing it to overload. If using standard speaker wire, unscrew each plastic bind until you are able to see an interior hole for speaker wire (this is easier to locate when viewing from a side angle). Slide the speaker wires into the slots and tighten the plastic binds to tighten them in place. Be sure there is no insulation on the speaker wire preventing conductivity. 4 www.PyleUSA.com Getting Connected Mic(s) connection Mic with Remote Key Control Using a mic cable with a 1/4"end, connect the mic to either of the Unit microphone inputs. E ects Loop Connections Source Music (Music from a DVD or CD player) By using the built-in Effects Loop you can add effects such as a professional Digital Key Controller to the source player's music without compromising the quality of the original signal. To use the effects loop connect an RCA cable from the unit's EFFECTS LOOP L or R OUT jack to the effects unit input. Then connect an RCA cable from the effects unit output, into the unit's L or R IN jack. Vocals MIC INSERT jacks on the rear panel to loop the vocals through effects unit. NOTE: In order to do this you must have a 1/4" Y adapter cable (not included) for each microphone line. Connect the single end of Y cable into the MIC INSERT jack. Connect one side of the double end into the input on the effects device and the other end into the output of the effects device. NOTE: There will be no sound if the Y cable is plugged into the unit but the double ends are not connected to the IN and OUT of the device. Connect the Remote Key Control cable into the KEY CONTROLLER jack on the rear panel of the unit. NOTE: If you are not using the Effects Loop, Be sure the LOOP BARS are re-connected. Without these, there will be no sound. 5 www.PyleUSA.com