RCA ANT3038XR Owner/User Manual - Page 5
Step 8: Connect the boom brace, Step 9: Install the transformer
UPC - 044476071638
View all RCA ANT3038XR manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
English Step 8: Connect the boom brace Lay the boom brace on top of the antenna. Make sure the mast clamps (the brass-colored sections) on the boom brace and antenna are facing the same direction. Fig. 8 Locate the screw hole in the reflector boom and attach the brace with one of the provided #10 screws and nuts. (See figure 8.) Fig. 9 Screw Swing the boom brace down towards the Nut rear. Form a "V" with the metal straps. Use one of the provided #10 screws and nuts to attach the "V" to each side of boom. (See figure 9.) Step 9: Install the transformer Find the downlead connection on the bottom of the front section of the antenna, just beyond the reflector booms. Place two washers on each of the studs. Place a #10 nut on top of each stud, but don't tighten them yet. Place the transformer ends between the two washers and tighten the nuts securely. (See figure 10.) Attach the coax downlead to the transformer. Fig. 10 Downlead Transformer connections 5