Ricoh C222DN Operating Instructions - Page 93
Mode 2, Anti-humid, System, Status, Possible Causes, Descriptions, and Solutions
UPC - 026649060113
View all Ricoh C222DN manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Other Printing Problems Status Possible Causes, Descriptions, and Solutions Multiple pages are fed at once. • There may be a gap between the front end paper guide and the paper, or between the paper guide both side and the paper in the paper tray. Make sure there are no gaps. See p.34 "Loading Paper". • Paper is either too thick or too thin. See p.23 "Paper and Other Media". • Paper has already been printed on. See p.23 "Paper and Other Media". • Number of paper set in the tray exceeds the limit. Confirm that the top of the stack is not higher than the limit mark inside the tray. See p.23 "Paper and Other Media". • Paper is static. Use paper that has been stored properly. See p.23 "Paper and Other Media". • The friction pad, paper feed roller, or registration roller might be dirty. Clean the relevant component. See p.66 "Cleaning the Friction Pad and the Paper Feed Roller" and p.69 "Cleaning the Registration Roller". • Check that paper was not added while there was still some left in the tray. Only add paper when there is none left in the tray. • Fan the paper before loading. Paper gets wrinkles. • Paper is damp. Use paper that has been stored properly. See p.23 "Paper and Other Media". 7 • Paper is too thin. See p.23 "Paper and Other Media". • There may be a gap between the front end paper guide and the paper, or between the paper guide both side and the paper in the paper tray. Make sure there are no gaps. See p.34 "Loading Paper". The printed paper is curled. • Load the paper upside down in the paper tray. • Pull out the extender of the output tray. • If the paper curl is severe, take prints from the output tray more frequently. • Paper is damp. Use paper that has been stored properly. See p.23 "Paper and Other Media". • Log on to Smart Organizing Monitor as an Administrator, and then select [Mode 2] or [Mode 3] in the [Anti-humidity:] list on the [System] tab. Note that the first print takes longer than subsequent prints to complete. 83