Rocketfish RF-G1502 User Manual - Page 8

STEP 2 - Option 2: Installing on a solid concrete or concrete block wall CAUTION: To prevent property damage or personal injury, never drill into mortar between blocks. Mount wall plate directly onto the concrete surface. 1 Align the wall plate template (I) at the height you determined in the previous step and make sure that it is level. Tape the wall plate template to the wall, then use a pencil to mark the lag bolt hole locations (2). Remove the wall plate template. 2 Drill pilot holes to a depth of 3 in. (75 mm) using a 3/8 in. (10 mm) diameter masonry drill bit. 3 Insert concrete wall anchors* into the pilot holes and use a hammer to make sure the anchors are flush with the concrete surface. 4 Align the wall plate (H) with the anchors, insert the lag bolts (F) through the holes in the TV bracket, then tighten the lag bolts only until they are firm against the TV bracket. CAUTION: Avoid potential injuries or property damage! DO NOT over-tighten the lag bolts (F). *Not included. Call Customer Service to have the Fischer UX10 x 60 concrete anchor kit (Kit# CMK1) shipped directly to you. 8 Need help? Call 1-800-620-2790 (U.S. and Canada)