Ryobi A25RT03 Operation Manual - Page 13
Making Insert Plate Level, Attaching The Fence Assembly, Inserting And Removing Throat Plates
View all Ryobi A25RT03 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
ASSEMBLY INSTALLING THE ROUTER/INSERT PLATE ASSEMBLY See Figure 11. INSERT PLATE n Unplug the router table and/or the router. n With the insert plate installed on the router, insert router and insert plate assembly into the router table with the notch in the insert plate facing the back of the router table 3 2 away from the switch box. 1 0 1 Inch n Install the insert plate screws and leave loose until all adjustments have been made. STRAIGHT EDGE HEX KEY ADJUSTING SCREWS MAKING INSERT PLATE LEVEL See Figure 12. n Unplug the router table and/or the router. n Check to see if the insert plate mounted assembly is level with a straight edge or level. n Loosen insert plate screws. n Using the supplied hex key, tighten or loosen the adjusting screws depending on how the insert plate needs to be adjusted in order to make the insert plate level. n Tighten insert plate screws with a screwdriver. DIFREEECDTION 3 2 1 0 1 Inch FENCE LOCK KNOB WASHER Fig. 12 FENCE FENCE LOCK KNOBS ASSEMBLY ATTACHING THE FENCE ASSEMBLY See Figure 13. n Unplug the router table and/or the router. Place the router table right side up with the back edge closest to you. n Slide the carriage bolt washers onto the carriage bolts. Slide carriage bolts through the slot in the router table and through the slots in the fence assembly. Slide the fence lock knob washer over the carriage bolts. Install the fence lock knobs over the carriage bolts. Tighten the fence lock knobs. WARNING: Make sure throat plates snap securely into place. Do not use if snaps are damaged or throat plates do not snap in securely. Failure to do so could result in serious personal injury. 0 3 2 1 0 1 Inch SLOT CARRIAGE BOLT WASHER CARRIAGE BOLTS THROAT PLATE Fig. 13 TAB INSERTING AND REMOVING THROAT PLATES 3 See Figure 14. 2 1 0 The throat plate provides a stable surface around t1he cutter and prevents objects from falling through theIntchh roat plate and damaging the spindle. The proper size throat plate depends on the size and shape of the cutter. When inserted, the throat plate opening should be within approximately 1/4 in. of the outermost edge of the cutter. n Unplug the router table and/or the router. Select the throat plate you wish to use. 13 - English NOTCH DIFREEECDTION 2 1 0 Fig. 141 Inch