Ryobi P460KN Operation Manual - Page 7

ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the tool and any accessories from the box. All items listed in the Includes section must be included at the time of purchase. WARNING: Items in this Assembly section are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. n If any parts are damaged or missing, please call 1-800-525-2579 for assistance. WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: Do not attempt to modify this product or create accessories or attachments not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. CONNECTING THE PEN HOLDER AND FLEX SHAFT TO THE ROTARY TOOL CONSOLE See Figure 1, page 11. WARNING: Always hold the hand piece firmly in your hand. To avoid serious injury, do not mount the flex shaft hand piece into any hobby station. n Slide the flange on the pen holder into the opening on the side of the rotary tool console until it is fully seated. NOTE: Once fully seated, the tab on the flange will snap into the housing, preventing the pen holder from being removed. n Place the collar of the flex shaft onto the threaded outlet on the rotary tool console. n Turn the collar clockwise and tighten securely. OPERATION WARNING: Do not allow familiarity with this product to make you careless. Remember that a careless fraction of a second is sufficient to inflict serious injury. WARNING: Always remove battery pack from the tool when you are assembling parts, making adjustments, changing accessories, cleaning, or when not in use. Removing battery pack will prevent accidental starting that could cause serious personal injury. WARNING: Always wear eye protection with side shields marked to comply with ANSI Z87.1. Hearing protection may also be required depending on the type of attachment used and as prescribed elsewhere in this Operator's Manual. Failure to do so could result in objects being thrown into your eyes and other possible serious injuries. WARNING: Do not use any attachments or accessories not recommended by the manufacturer of this product. The use of attachments or accessories not recommended can result in serious personal injury. APPLICATIONS You may use this product for the purposes listed below:  Cutting  Sanding  Polishing and buffing  Engraving  Drilling KEY HOLE HANGER To mount the rotary tool console, use the key hole hanging feature. Screws should be installed so that the center distance is 5 in. 7 - English