Ryobi P507 Manual 1 - Page 6
Features, Assembly - saw
View all Ryobi P507 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
FEATURES PRODUCT SPECIFICATIONS Motor 18 Volt DC Blade Diameter 6-1/2 in. Blade Arbor 5/8 in. Cutting Depth at 0 2-1/16 in. Cutting Depth at 45 1-7/16 in. No Load Speed 4,700 r/min. (RPM) ASSEMBLY UNPACKING This product requires assembly. n Carefully remove the product and any accessories from the box. All items listed in the Includes section must be included at the time of purchase. WARNING: Items in this Assembly section are not assembled to the product by the manufacturer and require customer installation. Use of a product that may have been improperly assembled could result in serious personal injury. n If any parts are damaged or missing, please call 1-800-525-2579 for assistance. WARNING: If any parts are damaged or missing do not operate this product until the parts are replaced. Use of this product with damaged or missing parts could result in serious personal injury. WARNING: ATTACHING THE BLADE See Figure 1, page 12. WARNING: A 6-1/2 in. blade is the maximum blade capacity of the saw. Never use a blade that is too thick to allow outer blade washer to engage with the flats on the spindle. Larger blades will come in contact with the blade guard, while thicker blades will prevent blade screw from securing blade on spindle. Either of these situations could result in a serious accident. Remove the battery pack from the saw. n Remove the blade wrench (5 mm hex key) from the stor- age area. n Depress the spindle lock button and remove the blade screw and outer blade washer. NOTE: Turn the blade screw clockwise to remove. NOTICE: To prevent damage to the spindle or spindle lock, always allow motor to come to a complete stop before engaging spindle lock. Do not attempt to modify this product or create accessories not recommended for use with this product. Any such alteration or modification is misuse and could result in a hazardous condition leading to possible serious personal injury. NOTE: Do not run the circular saw with spindle lock engaged. n Wipe a drop of oil onto the inner blade washer and outer blade washer where they contact the blade. WARNING: WARNING: To prevent accidental starting that could cause serious personal injury, always remove the battery pack from the product when assembling parts. If inner blade washer has been removed, replace it before placing blade on spindle. Failure to do so could cause an accident since blade will not tighten properly. n Fit the saw blade inside the lower blade guard and onto the spindle. NOTE: The saw teeth point upward at the front of the saw. n Replace the outer blade washer. n Depress the spindle lock button, then replace the blade screw. Tighten the blade screw securely by turning it counterclockwise. 6 - English