Ryobi P530 English Manual - Page 12
Installing Battery Pack, Removing Battery Pack, Starting/stopping Speed Saw, Caution, Operating
View all Ryobi P530 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION INSTALLing BATTERY PACK See Figure 6. Place battery pack on the speed saw. Align raised rib on battery pack with groove in saw's bat- tery port. Make sure the latches on each side of the battery pack snap in place and that battery pack is secured on the tool before beginning operation. REMOVing BATTERY PACK See Figure 6. Locate latches on side of battery pack and depress both sides to release battery pack from the speed saw. Remove battery pack from the speed saw. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installation of the battery pack can cause damage to internal components. STARTING/STOPPING SPEED SAW See Figure 7. Follow these directions when starting and stopping the speed saw. To start: Depress switch to the On ( I ) position. To stop: Depress switch to the Off ( O ) position. CAUTION: We suggest that you practice with your speed saw before installing a bit and making cuts. OPERATing the SPEED SAW See Figure 8. Hold speed saw firmly with both hands. Start speed saw. Tilt speed saw at a 45o angle. Plunge bit into material using guide ring as a pivot. Raise speed saw slowly to a 90o angle. Begin cutting. DANGER: Do not cut electrical outlet openings with live electrical wires. Do not cut walls that may have live electrical wiring behind them. Shut off breakers or remove fuses to disconnect the circuit. Always hold the tool by its motor housing. 12 BATTERY PACK DEPRESS DEPRESS LATCHES Fig. 6 on off Fig. 7 Fig. 8