Ryobi P600 English Manual - Page 12
Charging A Hot Battery Pack, Installing The Battery Pack, Warning, Caution, Removing The Battery
View all Ryobi P600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
OPERATION CHARGING A HOT BATTERY PACK When using the tool continuously, the batteries in the battery pack will become hot. You should let a hot battery pack cool down for approximately 30 minutes before attempting to recharge. When the battery pack becomes discharged and is hot, this will cause the green LED to come on instead of the red LED. After 30 minutes, reinsert the battery pack in the charger. If the green LED continues to remain on, return battery pack to your nearest Ryobi Authorized Service Center for checking or replacing. Note: This situation only occurs when continuous use of the tool causes the batteries to become hot. It does not occur under normal circumstances. Refer to "CHARGING A COOL BATTERY PACK" for normal recharging of batteries. If the charger does not charge your battery pack under normal circumstances, return both the battery pack and charger to your nearest Ryobi Authorized Service Center for electrical check. installing the BATTERY PACK See Figure 5. NOTE: The battery pack is shipped in a low charge condition. Therefore, it must be charged prior to use. Refer to page 11, "CHARGING THE BATTERY PACK" for charging instructions. n Place the battery pack in the trimmer. Align the raised rib on the battery pack with the groove inside the trimmer, then slide the battery pack into the trimmer. WARNING: Always be sure the switch is in the OFF position before installing the battery pack. Failure to do so could cause accidental starting, leading to serious personal injury. n Make sure the latches on each side of your battery pack snap into place and the battery pack is secured in the trimmer before beginning operation. CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with the bottom of the tool and latches into place properly. Improper installation of the battery pack can cause damage to internal components. REMOVING the BATTERY PACK See Figure 5. n Locate the latches on the side of the battery pack and depress them to release the battery pack from the trimmer. n Turn the switch to OFF and remove the battery pack from the trimmer. YELLOW LED BATTERY PACK SHOWN IN CHARGER GREEN LED RED LED P110 CHARGER Fig. 4 depress latches to remove battery pack BATTERY PACK latch Fig. 5 12